EZ Air Ride Platinum Air Suspension Kit 1991-1996 Buick Roadmaster
373-PL91RM
Product Q&A
View Now
Click image to zoom
7-Gallon Tank
This custom designed tank features specially designed brackets that act as feet so the tank will mount easily in your trunk. This tank comes with 5 ports total - (2) 3/8" ports on the ends, (2) 1/2" ports on the opposing faces, and a 1/4" port for the drain on the bottom.
A common misconception with an aluminum tank is that users do not have to worry about rust. True, aluminum does not rust. But condensation will occur in any tank, getting into your air lines and valves causing rust and contaminating other major components. EZ Air Ride tanks are made of steel and has a coating inside and out for years of corrosion protection. This tank will last as long as you let it, if properly taken care for.
Tank Specs:
Viair 444c Chrome Compressor
This heavy duty compressor brings the performance of a Viair 480C at less cost, less weight and less heat. This compressor is designed from the ground up to provide insane reliability paired with the performance you expect from a Viair product. The 444C air compressor features a brand new, patent-pending, "intercooler" head design that helps disperse heat much more efficiently! It will fill a 2.5 gallon (11 liter) tank from 0 to 200 PSI in five minutes reliably and recharge from 165 back to 200 PSI in under a minute and a half!
AVS 3-ROCKER Switch Controller - 2-Way System
This controller is for a 4-valve setup. Top switch controls front up/down. Bottom switch controls rear up/down. Middle switch does all up/down (pancake).
Technical Note: The Classic Kit is a 2-way system design which means one switch controls the pressure in a pair of air bags. That means, on a typical vehicle with four airbags, you have one valve and air line for the two front airbags and only one valve and air line for the two rear airbags. While cornering, with a 2-way system, the airbag being compressed or "loaded" will transfer and increase the air pressure to the opposite side air bag. This pressure transfer will "lift" the side of the car on the inside of the turn, increasing body roll which greatly decreases handling characteristics. When using a 2-way system, it is strongly recommended that a sturdy front and rear sway bar (anti-roll bar) be used.
A 4-way system has four air valves, which allows you to better "tune" your ride and handling however you see fit. A 4-way dedicates a single valve and air line to each airbag which means the pressure you set for that airbag remains constant, no matter what! Which means, plain and simply, A 4-way system presents a much more stable, predictable and safe handling vehicle.
GP2W Dual Needle Single Gauge Panel
The Platinum kits gauge panel features a single domed glass, dual-needle gauge (an EZ Air Ride exclusive design). These billet gauge panels were designed to give you that classic look when mounting them in your vehicle.
EZ Air Ride 1/2" Electric Air Valve
Our brand new EZ Air Ride valve is the latest evolution in a line of valves known for reliability, speed, and low price. Featuring a 280 psi maximum operating pressure (although these have been known to exceed 300 psi), 1/2" ports, and a high 4.5 cV rating, these valves are designed to get your ride moving quickly! Each valve includes a DIN-style electrical plug for a weather-tight connection. We have made sure to match or exceed the performance and reliability of your favorite brands such as: Blitzluft, Danz, Parkers, SMC, Ascos, etc.. The EZ Air Ride valve even has a LED indicator to the solenoid for trouble shooting and diagnostics. Whether you want a nice smooth ride or you're looking to crank up the nitrogen bottle to these bad boys, you will not be disappointed!
Valve Specs:
Classic Fitting Pack
This pack comes with all of the EZ Air Ride fittings you need to assemble an EZ Air Ride kit. This fitting pack is compatible with any 2-way gauge system that consists of (2) paddle valves, (1) dual needle pressure gauge, (4) half inch ported air bags, and any air tank with (2) 3/8" bungs, (2) 1/2" bungs, and a 1/4" drain bung.
Pack Includes:
1991-1996 Buick Roadmaster Front Air Bag Brackets
EZ Air Ride "SET IT AND FORGET IT" line of brackets were designed with you in mind. They have custom made these brackets to fit your specific year vehicle. They are 100% bolt on and require absolutely no welding. Just bolt these in place of your factory coils and you're done. It's as simple as that; just SET IT AND FORGET IT. Each and every bracket is powder coated, labeled and includes all necessary hardware.
1991-1996 Buick Roadmaster Rear Air Bag Brackets
EZ Air Ride "SET IT AND FORGET IT" line of brackets were designed with you in mind. They have custom made these brackets to fit your specific year vehicle. They are 100% bolt on and require absolutely no welding. Just bolt these in place of your factory coils and you're done. It's as simple as that; just SET IT AND FORGET IT. Each and every bracket is powder coated, labeled and includes all necessary hardware.
Air-Lift Dominator Air Bags
The Air Lift Performance Dominator features an unprecedented maximum restrained pressure of 600 psi. This bad boy will give you the performance you crave. With more lift, a softer, smoother ride, and the lowest price in the industry, you can't go wrong with the new Dominator! This air bag features a single 1/2" port.
EZ Air Ride Front Shock Relocation Kit
Aftermarket-engineered for an OE like performance, EZ Air Ride's shock absorbers provide high-quality performance at an affordable price. While providing superior response and consistent control, EZ Air Ride shocks feature a super-finished chromed piston rod for corrosion resistance and a leak-proof piston seal which extends product life. This shock relocation kit has been designed to work with almost all of our air ride kits, giving the user the ability to safely and easily relocate their shocks and give their vehicle that perfect stance.
Shock Kit Includes:
What makes their kit superior to any other kit is the open side on the shock tower. This gives the user more adjustability when installing their shocks. The EZ Shock absorber has a lower eyelet that bolts on to the lower A-arm shock stud. As well as the top shock stud that simply bolts thru the shock tower. Not to mention, they have one of the only shocks that will closely match the Air Lift air bag's stroke.
Shock Installation Note: All of the EZ Air Ride brackets are 100% bolt on, although, they do recommend welding the shock towers to your frame for a cleaner and easier install.
Leak Free EZ Air Tube
This D.O.T. Nylon Reinforced Air Line is manufactured by EZ Air Ride and made out of Nylon with leak free technology. They supply you with enough of this air line to bag your entire ride.
EZ Air Ride Survival Kit
Don't let the other guys charge you $50-$80 for this kit, EZ Air Ride includes it for free!
Survival Kit Includes:
EZ Air Ride Spare Air Kit
EZ Air Ride brings you the all new Spare Air Kit! Now you can fill up your tires, spray off dust or water with your on board air. The Spare Air kit includes a special brass "T" fitting to connect your pressure switch and a quick connect valve to your 7-Gallon EZ Air Tank. Our Spare Air kit also allows you to fill up your air tank with the compressor in your garage or at a gas station. EZ Air Ride suspension kits are the first and only to now feature on board air as a no-cost luxury that comes standard in every kit. Make your air ride kit more universal with EZ Air Ride's all new Spare Air.
Spare Air Kits Include:
Specifications:
Part Type
Product Line
Part Category
Performance Parts
ARNOTT / PARTS AUTHORITY A-2173 Features: Arnott's air spring A-2173 for the rear right side of the 1995-2002 Lincoln Continental is assembled in the USA using only the highest-quality materials. This rugged air spring is made with high impact resin ...
ARNOTT / PARTS AUTHORITY A-2504 Features: Arnott's new product line for the rear of the BMW X5 includes a new rear air spring featuring a Continental ContiTech bladder assembled with the highest-quality materials and backed by Arnott's Limited Lifetime Warranty! ...
Some parts are not legal for use in California or other states with similar laws / regulations
Motor Vehicles
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
Tools:
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
Electrical Cords
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.