Eastwood 13395 - Eastwood Poly-X Paint and Rust Removal Disc
Eastwood#352-13395Poly-X Paint and Rust Removal Disc
This Eastwood 4.5'' Cup Style Poly-X Paint and Rust Removal Disc allows you to strip and clean paint and rust from metal with little effort without removing excessive metal. Easily attaches to your drill.
Manufacturer's Part Number:
Rated 5 out of 5 by xelit0 from Great product Works very well even on oil based paint for steel stair handrails. A little expesive like someone else said but it's a big time saver when stripping paint. Wears out a tad faster than if u were using it on a car but I wouldnt hesitate to use it again. Need to order some more to get the job done. Thats how well it works.
Date published: 2015-05-01
Rated 4 out of 5 by Joe matt from Removed paint fast! But... Ordered 5 of these wheels to strip my bed to bare metal, wheels did a great job and stripped to bare metal quickly. Only issue is that they where out fast, only recommendation i have is to order a couple more than what you think you need, I used 5 of these wheels plus 4 from harbor freight.
Date published: 2015-05-04
Rated 5 out of 5 by willy123 from Paint and rust removal disk I bought this for help with removing paint & rust while restoring my old mustang. It is working very good at this time .I will know more about how long it lasts while using it .
Date published: 2015-01-17
Rated 5 out of 5 by heliboy from Let it do the work. I bought several (10 I think) of these to completely strip a 1976 Ford Maverick 2 door that had full paint AND Rust Bullet sealer on the metal. I used a Harbor Freight 4 inch grinder and had to add 3 small strips of duct tape to each inner section of the wheel to ensure they would seat on the collet correctly without slipping - no biggie. Doesn't take a lot of pressure, and don't try to hold them at an acute angle or else you end up with the edges thinned out with a thick center section. A slight angle is all that is needed and you end up with even wear over the entire disc. You can use the disc clean down to the plastic mount it is on, so don't be afraid to take it as far down as possible to get your money's worth. Very little heat on the metal unless you stay in one spot. Cuts very nicely, and just let it do the work. Don't go real fast, and yet you don't have to go real slow unless your surface it is cutting is pretty thick. In which case just slow down and let it work. If need be cut the top coat and then cut the bottom with a 2nd pass - works better & lasts longer than trying to do it all at once. Good product I think.
Date published: 2015-04-13
Rated 5 out of 5 by gregteubert from paint and rust remover cuts threw years of Texas paint strip paint down too metal and then i sealed the fenders with primer and it did not heat the metal up did a great job
Date published: 2014-11-04
Rated 4 out of 5 by ron mopar guy from It works Bought this for resto project. Just make sure you scrap off any glue or sealer, because it will cake-up. Does the job and removes rust.
Date published: 2014-12-18
Rated 5 out of 5 by B Bowers from Poly-X Disc Strips paint off metal fast! Great to use to when a hurry
Date published: 2014-09-11