Global West CNR-88A - Global West GM Negative Roll Control Arms

Global West CNR-88A - Global West GM Negative Roll Control Arms

Global West #459-CNR-88A

Upper Control Arms
  • Fits GM G-Body
  • Del-A-Lum bushings
    • $541.99 Ships 02/29/12
    Share |


    Global West CNR-88A - Global West GM Negative Roll Control Arms

    Global West CNR-88A - Global West GM Negative Roll Control Arms Details

    Upper Control Arms

    Applications

  • 1978-88 Chevy Chevelle, El Camino, Monte Carlo
  • 1978-88 Buick Century and Regal
  • 1978-88 Oldsmobile Cutlass and 442
  • 1978-88 Pontiac GTO, Le Mans, Tempest, and Grand Prix<
    When using the arms on GM G-bodies, GM tall spindles are required. Spindle tapers for this conversion are the same as the standard, shorter spindle.

    • Global West CNR-88A - Global West GM Negative Roll Control Arms

    These arms are designed to change factory suspension pickup points to induce negative camber as the wheel goes up into the fender. The extra negative camber generated by the arms will keep a greater portion of the tire on the ground, which increases the vehicle's cornering ability.

      Highlights

  • Better geometry curve
  • Built-in bump stops
  • Load carrier ball joints
  • Special billet offset shafts

    Installation Notes

  • When using the arms on GM A-bodies, GM tall spindles, machined lower ball joints, and different outer tie rods are required. For 1964-70 A-bodies, use outer tie rod part #459-3007; for 1971-72
    A-bodies, use #459-3008.
  • Negative roll systems will drop the front ride height 1 inch because of the taller spindle and lower ball joint combination. The maximum backspacing on 1964-72 A-bodies is 5-7/8" with a 17" wheel,
    5" with a 16" wheel, and 4-1/2" with a 15" wheel.
  • When using the arms on GM G-bodies, GM tall spindles are required. Spindle tapers for this conversion are the same as the standard, shorter spindle.
  • Factory upper control arms cannot be used with negative roll systems because they are too long, and they won't allow for proper alignment.
  • Factory lower control arms can be used in negative roll systems, but they will require machined lower ball joints (part #459-2005).

    • Accessories
    - Items You May Need
    Always a great choice. Add one to your cart today!
    JEGS Performance Products 80120JEGS Ratchet Tie-Downs
    JEGS Performance Products 80120 - JEGS Ratchet Tie-Downs
    Only $20.99
    Cornerstone Leadership NOECAL001Cornerstone Leadership Motivational Books/Calendar
    Cornerstone Leadership NOECAL001 - Cornerstone Leadership Motivational Books/Calendar
    Only $17.99
    JEGS Performance Products W1719Performance Tool Hand Tools & Accessories
    JEGS Performance Products W1719 - Performance Tool Hand Tools & Accessories
    Only $16.99