Free Shipping on Auto Parts Orders Over $75.                           Order by 11 PM EST for Same Day Shipping!

JEGS Performance Products 15426 - JEGS CNC Poly-Billet Carb Spacers



JEGS Performance Products 15426 - JEGS CNC Poly-Billet Carb Spacers
JEGS Performance Products 15426 - JEGS CNC Poly-Billet Carb Spacers

JEGS Part Number: 555-15426

CNC Poly-Billet Carburetor Spacer
  • 4150
  • Open
  • 1" Spacer
  • Made in the USA
    Includes:
  • (2) Carburetor Gasket
  • Carburetor Studs, Nuts & Washers
      $32.99 Ships

    JEGS CNC Poly-Billet Carb Spacers

    The Ultimate Carb Spacer!

    CNC Poly-Billet Spacers:
    Our CNC machined extreme-poly carb spacers are available in three heights for your tuning requirements. These spacers were designed to lower the transfer of heat from the intake manifold to the carb keeping the fuel at lower temperature for an increase in power. The fine tuning advantages with spacer heights due to track or altitude conditions can give you an edge on your competitors. Complete with gaskets and mounting hardware for easy installation. Made in the USA.
    Not for use with stock manifolds with heat crossovers, can withstand temperatures to 400°.

    "The Edge" Carb Spacers:
    If you already have the standard carb spacer and are looking for performance improvement then you need to look over the "Edge". For those who are extremely serious and over the "Edge", here is the ultimate in carb spacers. We have taken the 4-Hole spacer to the limit in development. It now features the Flow-Enhancer Cavity. This CNC machined cavity enhances flow and increases power and also aides in consistency when used in conjunction with under carburetor throttle stops. Gains of 10 to 50 hp have been seen depending on your combination. Complete kit with gaskets and mounting hardware for easy installation. Made in the USA.
    Not for use with stock manifolds with heat crossovers, can withstand temperatures to 400°.

    Items similar to JEGS Performance Products 15426

    Rated 5 out of 5 by from Good fit, easy to install. It came with 2 inch studs which just had enough threads for my Holley carburetor. If throttle and transmission cable bracket is to be used and attached to base of carburetor, 2-1/2 inch studs should be ordered separately.
    Date published: 2016-01-04
    Rated 4 out of 5 by from Great spacer Great spacer well made good fit easy install bolt kit could be better
    Date published: 2015-10-07
    • 2016-04-29T07:50CST
    • bvseo_cps, prod_bvrr, vn_cps_3.2.0
    • cp_1, bvpage1
    • co_hasreviews, tv_0, tr_2
    • loc_en_US, sid_10001_10001_83346, PRD, sort_relevancy
    • clientName_jegs
    Items You May Also Consider
    Only $16.99

    Ships
    Only $31.59
    Order Today
    Ships 05/04/16
    Only $36.41

    Ships
    Grime Boss A541S30X - Grime Boss Hand Wipes
    Only $4.99

    Grime Boss A544R10X - Grime Boss Hand Wipes
    Only $2.69