All New ATAC Advanced Thermal Acoustic Coating - A revolution in automotive interior comfort! A one-step solution to control both heat and sound. ATAC coating is designed to transform the interior of your vehicle into an oasis of comfort. Say goodbye to the discomfort of excessive heat and annoying noise, and say hello to a serene, cool, and quiet ride!

Upgrade your driving experience with ATAC Advanced Thermal Acoustic Coating and discover a new world of comfort and quiet. It's time to silence the noise, beat the heat, and elevate your vehicle with ATAC.

Design Engineering Inc. 50208 ATAC Thermal Coating Features:

• A spray-on, roll/brush-on, 2-IN-1 SOUND AND HEAT BARRIER for automobile interiors that saves time & money
• Unique Hi-Tech ceramic micro-sphere technology dampens noise & vibration while reflecting heat up to 375°F
• Water-based coating cleans up easily and covers approximately 75sqft
• Non-toxic and water soluble

Design Engineering Inc. 50208 ATAC Thermal Coating Notes:

FOR INTERIOR USE ONLY

ATAC is designed exclusively for coating unfinished automotive interiors. Do not apply ATAC to the exterior of any vehicle, motorcycle, RV, SXS or on any surface that will be submerged under water. Do not apply on plastics or other surfaces that are not manufactured from steel or aluminum. Before applying ATAC, thoroughly prepare the surface by following our instructions below. Contact DEI if you have questions on where to apply ATAC or what surface to apply ATAC to.

Surface Prep

• Surface should be clean and free from oil, grease, wax, and contaminants
• Rust should be removed or treated. Bare metal should be primed. We recommend a red oxide primer
• Painted surfaces should be scuffed before applying
• Do not apply in temperatures below 60°F (Do not let freeze.)
• The surface temperature should be no lower than 60°F

Application Procedure

Can be brushed/rolled on or spray applied. Stir before use. Do not over-stir or shake. Keep container sealed and airtight for storage.

• Test any section in a small area.
  • Prime over galvanized surfaces.
• Apply uniform wet coat of 12-16 mills thick.
  • A second coat can be applied if needed.
  • Allow 12 hours between coats.
  • Allow 24 hours @ 70°f to cure before covering with any materials or applying heat from engine/exhaust systems.
  • High humidity and lower temps will increase drying time.
• Do not force dry with heat.
• Clean up with hot water and soap.