FREE SHIPPING & HANDLING!*                           Order by 11 PM EST for Same Day Shipping!

MSD Ignition 7761 - MSD Power Grid Ignition System

MSD Ignition 7761 - MSD Power Grid Ignition System

MSD Ignition#121-7761

Advanced RPM Control Module
  • Sets Rev Limits Based On Slew Rate OR Time Since Launch
  • For Use With Power Grid System

    MSD Ignition 7761 - MSD Power Grid Ignition System Details

    Accessory Modules

    "Racing on the Dots," is being taken to the next level with this module. Now there is even more control with the PN 7761 module for the Power Grid System Controller. This module sets rpm limits based on slew rate (rpm acceleration) or based on time since launch. All of this is programmed seamlessly in MSD View.
    Key Features:

  • Set RPM limits based on engine or driveshaft acceleration
  • Fully programmable with MSD view with multiple retards & rev limiters
  • For use with Power Grid Controller

    Note: 4-Connector CAN-Bus Hub (121-7740) Required. Go to MSDIGNITION.COM to update your Power Grid before using module.

  • MSD Ignition 7761 - MSD Power Grid Ignition System

    The Power Grid Ignition System is the next evolution of the Programmable 7-Series Ignition Controls. The Grid incorporates an efficient 32 bit microcontroller and an all new software program, called MSD View, and is USB compatible. The Windows based software is designed with tabs to help racers easily select different programming windows and parameters. Also, the data acquisition files of the ignition are now captured on a micro SD card for ease of storage and reviewing.

    The Power Grid Ignition incorporates CAN-BUS technology which reduces the amount of wiring and simplifies the addition of accessory modules. The CAN-BUS is a common harness that accessory controls are connected to and easily brought into the programming library of the View Software. With this technology, racers can connect the Power Grid system directly into their Racepak Data Recorder and other Racepak products.

    NOTE: To use any modules with the Power Grid System, users MUST plug the modules into a 4-Connector CAN-BUS Hub (# 121-7740) to be attached to the Power Grid System Controller (# 121-7730).

    The Power Grid Controller is the brains behind the entire system and can be used with any MSD Ignition or the Pro Mag to provide advance ignition tuning capabilities. While it is compatible with all MSD boxes, the new Power Grid System Controller has been specially designed to mount to the Power Grid Ignition Control box. Also, this new Ignition packs higher output than current programmable units!

    The Power Grid Controller is supplied with the View Software, wiring harness, micro-SD card and mounting hardware. The Power Grid Ignition Control Box, available separately, is supplied with the harness and mounting hardware.

    Powergrid System Flyer

    Features
  • USB connection for ease of programming
  • Timing based on engine RPM and gear value
  • Advanced individual cylinder timing based on gear or time
  • Five retard stages for nitrous
  • Four steps of RPM limits for burnouts, spool, launch and over rev
  • Direct connection to Racepack
  • Output switch set on RPM, pressure, or time
  • Shift light settings for each gear
  • Ignition data acquisition accepts multiple runs

    JEGS EZ Complete Kits are designed by JEGS professionals so you get all the parts you need.

  • Grime Boss A541S30X - Grime Boss Hand Wipes
    Only $9.99

    Grime Boss A544R10X - Grime Boss Hand Wipes
    Only $4.69