FREE SHIPPING & HANDLING!*                           Order by 11 PM EST for Same Day Shipping!

MSD Ignition 8509 - MSD Tach Adapter - Points or Amplifier and Magnetic Pickup

MSD Ignition 8509 - MSD Tach Adapter - Points or Amplifier and Magnetic Pickup

MSD Ignition#121-8509

Magnetic Signal Stabilizer
MSD® Rebate
Expires on September 30, 2014
Rebate 1

Buy any MSD product and get up to $50 in rebates! More Info

View All MSD Products

Expires on 08/31/14

Rebate 2

Buy a MSD 8.5mm Super Condutor Wire set and a 4, 6, or 8 MSD Spark Plugs and receive up to $15 in rebates! More Info

  • 8.5mm Super Conductor Spark Plug Wires
  • Spark Plugs

  • MSD Ignition 8509 - MSD Tach Adapter - Points or Amplifier and Magnetic Pickup Details

    The Magnetic Signal Stabilizer converts the signal from a magnetic pickup to a square wave trigger signal for the MSD Ignition Control.

    Note: Mount the unit away from direct engine heat sources.

    MSD Ignition 8509 - MSD Tach Adapter - Points or Amplifier and Magnetic Pickup







    Tach/Fuel Adapter, Points and Amplifier
    (Factory Ignition Module)

    If you are triggering an MSD Blaster, 5,6, or 7 Series Ignition with its white wire or points terminal, you will need this Tach Adpater. This unit will correct the operation of most voltage triggered tachometers or fuel injection systems that do not work directly off the tach output terminal of the MSD Ignition Unit.


    Magnetic Pickup

    If you are using the magnetic pickup input (green and violet wires) to trigger your MSD Ignition, you will need the #121-8920 Tach Adapter. This will correct the operation of most voltage triggered tachometers that do not work directly off the tach output terminal of the MSD Control. This Adapter should also be used on current triggered tachs (hooked in series with the ignition switch).

    Grime Boss A541S30X - Grime Boss Hand Wipes
    Only $9.99

    Grime Boss A544R10X - Grime Boss Hand Wipes
    Only $4.69