FREE SHIPPING & HANDLING!*                           Order by 11 PM EST for Same Day Shipping!

Moroso 97641 - Moroso Racing Vacuum Pumps & Accessories

Moroso 97641 - Moroso Racing Vacuum Pumps & Accessories

Moroso#710-97641

-12AN Replacement Fittings
  • 2/pkg

    Moroso 97641 - Moroso Racing Vacuum Pumps & Accessories Details

    Vacuum Pump Fittings

    These special clearanced fittings have radiused inlets to reduce restriction for greater flow. Fittings are anodized to prevent corrosion and come with an o-ring. Fitting for Moroso Vacuum Pumps, Remote Oil Filter Mount and Positive Seal Vent Fitting.

    Moroso 97641 - Moroso Racing Vacuum Pumps & Accessories

    The nature of a vacuum pump is to remove air, blow-by gases, and other contaminants from the crankcase of an engine. The vacuum pump's ability to remove the air in the crankcase results in overall engine vacuum. Vacuum will increase horsepower by allowing the use of low-tension compression and oil rings. The use of these pumps reduces frictional horsepower losses, blow-by, intake charge contamination and aids in detonation prevention. Moroso's "purpose built" racing pumps offer all these advantages and more. Whether you have a normally aspirated small block or a nitrous equipped pro-mod, one of Moroso's vacuum pumps with all the needed accessories has you covered. Use Moroso replacement pump fittings only. Moroso Vacuum Pump FAQs.


    Original Design Vacuum Pump
  • 3 or 4-vane pump
  • Billet aluminum housing
  • Pulls much more vacuum than stock smog pumps
  • Special vane material for improved seal and wear
  • -12AN inlet/outlet fittings won't leak
  • Rebuildable in 15 minutes
  • Mounting bracket sold separately

    Enhanced Design Vacuum Pump
  • 3 or 4-vane pump
  • Wet or Dry Sump useage
  • Anodized or natural exterior
  • Pulls 13.9% more vacuum and does so sooner
  • Sealed, maintenance-free bearings
  • -12AN fittings included

    Pro Mod Style Vacuum Pump
  • 4-vane pump
  • Achieves much greater vacuum sooner
  • Flows up to 150% more than original design
  • Capable of up to 26 inches of vacuum
  • Rotor is keyed to shaft, eliminating fastener failure
  • Pump weighs 7 lbs, 8 oz (with bracket and fittings)
  • Sealed, maintenance-free bearings
  • Billet bracket and -16AN beaded fittings included (bracket mounts to motor plate & rotates 360°)


    JEGS Easy Kits are designed by JEGS professionals so you get all the parts you need.

  • Items You May Also Consider
    JEGS Performance Products 100004 - JEGS AN Hose End Fittings - Blue/Red
    Only $13.99

    JEGS Performance Products 100014 - JEGS AN Hose End Fittings - Blue/Red
    Only $19.99

    JEGS Performance Products 100024 - JEGS AN Hose End Fittings - Blue/Red
    Only $19.99

    JEGS Performance Products 100941 - JEGS Pro-Flo 200 Series Stainless Steel Braided Hose
    Only $51.99


    See All Items You Need