PJ1 SP129 - VHT Engine Enamel

PJ1#322-SP129

Engine Enamel

Gloss White

Accessories

Complete list of VHT Engine Enamel

Overview
Accessories
Specification

VHT Engine Enamel is a unique formula of urethane resins that resist: fading, harsh solvents, corrosion, and 550°F temperatures. No other air-dry coatings withstand the contents of today's cleaners & fuel as well as VHT. Factory engine colors available for restoration and customization.

To Apply

Do not use in temperatures less than 70°F or on parts below room temperature

Thoroughly clean surface--remove all grease, oil, loose paint, and rust

Lightly sand any areas already painted, making sure to feather rough edges

Wipe parts to be painted with a tack cloth, carefully removing dust and debris

Primer is not required but you can spot prime as needed

Hold VHT can 12"-15" away from prepped surface

Spray enamel in one direction using long, steady strokes. Repeat in opposite direction.

Wait approximately 30 minutes before recoating--apply only enough to color surface evenly

Excessive application is unnecessary and will cause blistering and loss of adhesion

If touch-up is needed after 4 hours, light sanding may be required

To Cure
Whichever curing method you choose must be done slowly