FREE SHIPPING & HANDLING!*                           Order by 11 PM EST for Same Day Shipping!

PJ1 SP738 - VHT Spray-On Brake Paint

PJ1 SP738 - VHT Spray-On Brake Paint

PJ1#322-SP738

Spray-On Brake Paint
  • Bright Yellow
  • ORMD Item - Ground Shipping Only

    PJ1 SP738 - VHT Spray-On Brake Paint Details

  • Features EZ Touch Conical Nozzle
  • Ceramic Resins Resist Heat Up To 900 Deg. F
  • Fast Drying Durable Finish
  • Dry To Touch In 30 Minutes / Handle In 1 Hour
  • Resistant To Chipping/Chemicals/Brake Dust
  • For Use On Brake Calipers/Rotors/Drums

  • PJ1 SP738 - VHT Spray-On Brake Paint

    Get a Custom Look as You Protect Brake Drums, Calipers & Rotors from Rust, Salt, and Brake Dust

    Features

  • 11 oz can
  • Self-priming
  • Protects up to 900° F
  • Durable gloss or satin coating
  • Can be applied to aluminum or cast metals
  • Resists harsh weather, chemicals, chipping, cracking, and fading

    How to Apply
    Prepping Surface
    For maximum adhesion, start with a clean, dry surface. If surface is glossy or rusty, scuff with steel wool or similar pad.

    Masking Area
    To protect from overspray, cover and tape off wheel wells, lugs, floor, and other surrounding areas you do not want painted. However, overspray can be removed with mineral spirits immediately after paint application while surface is still wet.

    Painting
    Shake can for a full 2 minutes after the agitator ball begins to rattle. Repeat for 10 seconds after each 5 minutes of use. Spray a thin, even coat approximately 8" to 10" away from surface (or experiment with the distance to achieve desired finish). Repeat within 10 to 15 minutes until desired color is achieved. For maximum protection, spray a final coat 5" to 6" away from surface (be careful to avoid running).

    Curing
    Depending on humidity, paint dries to the touch in 15 to 25 minutes (air dries overnight). For increased heat and chemical resistance, apply heat within 7 days. Curing may also be accomplished due to the inherent heat of operation or in a proper oven.

    Additional Tips

  • Spraying front and rear brake systems will require 2 to 3 cans of paint
  • Test spray a small area before starting the project
  • Apply only when air temperature is 65° F to 95° F
  • Do not apply in high humidity unless parts will be oven cured
  • Apply multiple coats in less than 1 hour OR after 24 hours (coats sprayed between this period may not dry or adhere properly and/or wrinkle)

  • PJ1 322-SP738

    Color
    Yellow
    Application
    Caliper
    Grime Boss A541S30X - Grime Boss Hand Wipes
    Only $9.99

    Grime Boss A544R10X - Grime Boss Hand Wipes
    Only $4.69