Global West Control Arm Bushings and Shafts

Del-A-Lum Bushings Features and Benefits:

• Zero deflection fore and aft
• Perfect for street and race applications
• Smooth movement up and down
• Easy press-in installation for most applications
• Directly replaces factory bushings
• Fully greasable
• Low maintenance
• Quiet, will not squeak
• Limited Lifetime Warranty

  Offset Shafts can be used in the factory upper control arms and take the place of stock shafts. Offset shafts generally give you about 1-1/4 degree change. All shafts are made out of billet steel and are supplied with hardware for the shaft, but not for the frame. Standard non-offset shafts are also available and are highly recommended if you are using Del-A-Lum or polyurethane bushings. The shafts are made to accommodate 5/8'' fine threaded locking nuts rather than a factory shaft that uses a 3/8'' bolt holding the bushing in place.

  Offset Shaft Features and Benefits:
• Improved general alignment applications. Performance alignment setting is far easier to obtain with offset shafts. The shaft allows caster to be added without losing proper camber settings.
• Correcting alignment for frame sag or for frames that have been damaged.
• Obtaining specified alignment using tubular control arms.