Free Shipping on Auto Parts Orders Over $75.
Order by 11 PM EST
for Same Day Shipping!
Global West GM Negative Roll Control Arms
Product images may differ from actual product appearance.
These arms are designed to change factory suspension pickup points to induce negative camber as the wheel goes up into the fender. The extra negative camber generated by the arms will keep a greater portion of the tire on the ground, which increases the vehicle's cornering ability.
Better geometry curve
Built-in bump stops
Load carrier ball joints
Special billet offset shafts
When using the arms on GM A-bodies, GM tall spindles, machined lower ball joints, and different outer tie rods are required. For 1964-70 A-bodies, use outer tie rod part #459-3007; for 1971-72 A-bodies, use #459-3008.
Negative roll systems will drop the front ride height 1 inch because of the taller spindle and lower ball joint combination. The maximum backspacing on 1964-72 A-bodies is 5-7/8" with a 17" wheel, 5" with a 16" wheel, and 4-1/2" with a 15" wheel.
When using the arms on GM G-bodies, GM tall spindles are required. Spindle tapers for this conversion are the same as the standard, shorter spindle.
Factory upper control arms cannot be used with negative roll systems because they are too long, and they won't allow for proper alignment.
Factory lower control arms can be used in negative roll systems, but they will require machined lower ball joints (part #459-2005).
Narrow Results for Global West GM Negative Roll Control Arms