The Tin Man Subframe Connectors are the most robust on the market being made of 2" x 2" x 11 gauge steel and are bent to follow the contours of the floor pans - no cutting of the floor pan is necessary. This product drastically stiffens the body of the vehicle. These connectors will work on Mustang convertibles with minor cutting and welding to the floor reinforcement pan (typical on all convertibles).
These connectors fit the '71 - '73 Mustangs as well, however, the frame rails on these vehicles are approximately 2" wider. Therefore, during installation and once the connector is inserted into the front subframe, it will be necessary to clamp the rear of the connector to the side rail prior to welding. There will be some tension until the connector is welded into place.
Made of 2" x 2" x 11" gauge steel
Bent to follow the contours of the floor pan
No floor pan cutting necessary
Will drastically stiffen the body of the vehicle
Made in the U.S.A.