- Engines & Components
- Engine Tools
- VHT Engine Enamel
VHT Engine Enamel is a unique formula of urethane resins that resist fading, harsh solvents, corrosion, and 550°F temperatures. No other air-dry coatings withstand the contents of today's cleaners & fuel as well as VHT. Factory engine colors available for restoration and customization.
To Apply:
- Do not use in temperatures less than 70°F or on parts below room temperature
- Thoroughly clean surface--remove all grease, oil, loose paint, and rust
- Lightly sand any areas already painted, making sure to feather rough edges
- Wipe parts to be painted with a tack cloth, carefully removing dust and debris
Show More
- Primer is not required but you can spot prime as needed
- Hold VHT can 12"-15" away from prepped surface
- Spray enamel in one direction using long, steady strokes. Repeat in opposite direction.
- Wait approximately 30 minutes before recoating--apply only enough to color surface evenly
- Excessive application is unnecessary and will cause blistering and loss of adhesion
- If touch-up is needed after 4 hours, light sanding may be required
To Cure:
- Whichever curing method you choose must be done slowly
- Air: Enamel dries in 1 hour and cures overnight
- Booth: Bake 15 minutes at 300°F then 30 minutes at 350°F (improves durability and resistance to salt spray, chemicals, and humidity)
- Engine: Idle engine for 15 minutes and then let cool; idle engine again no more than 1 hour and let cool
- Operation: The inherent heat output during operation of an engine or exhaust can cure the enamel
Filter Results
AVAILABILITY
PART TYPE
PART TYPE
BRAND
BRAND
RATING
Color
Part Category
Vendor Part Number
Part Fitment
Application
Paint Type
Volume oz
PRICE