Unrivaled Customer Service
And Expert Tech Advice!  
Same Day Shipping Before 11 PM ET
My Cart
Shop By Vehicle
Shop By
Close Menu
Shop By Vehicle
Top Categories
All Categories

Top Categories

All Categories

Free Catalog
E-Mail Signup
My Account
Track Order
Gift Certificates

Baileigh TN-600 Abrasive Belt Pipe/Tube Notcher 6" Belt Width

Baileigh TN-600


jegs shipping
Estimated to ship directly from the manufacturer on 07/03/18
Easy Returns
Easy Returns
Lowest Price Guarantee
Lowest Price Guarantee
Truck Freight: $159.00
Baileigh TN-600 Abrasive Belt Pipe/Tube Notcher 6" Belt Width $5,895.99
TN-600 Abrasive Belt Pipe/Tube Notcher
  • 6'' Belt Width
  • 220-Volt (1-Phase)

  • Specifications:

    Manufacturer's Part Number:

    Baileigh Industrial's abrasive pipe notcher TN-600 uses industrial grade mechanical and electrical components and a logical design to notch through tubing and pipe with ease. This abrasive pipe notcher has a powerful 5-hp motor that notches at full capacity with ease and only requires 220-volts of single phase power, so it can be used in almost all fabrication shops.

    The spindle size allows for an industry standard 6'' x 79'' belt to be used. This 6'' wide surface allows this abrasive pipe notcher to cope at maximum capacity of 3'' OD at angles up to 60-degrees. Smaller 4'' wide belts can be used as well if notching only up to 2'' OD at angles up to 60-degrees. Additional mandrel spindles are required for each different OD to be notched.

    The belt drive on this powerful pipe notcher has a large diameter urethane drive wheel for maximum grip of the belt drive which is important when notching at maximum capacity. The motor and drive wheel on this tube notcher are on a spring suspension to take up any belt stretching that may take place and there is also a fine tune adjustment for belt tracking.

    The vice carriage on the TN-600 tubing notcher rides on a smooth Thompson shaft rail system, so when notching there is little effort to feed the pipe or tube into the spindle. A stop can be set up for high production runs of the same material. The vice has a quick change taper release system that allows the operator to change position on the belt or degree of angle in seconds. The vise has V-Jaws for a tight grip of the material and is perfect for light gauge to heavy gauge material. The vice is a self centering vise so the material can be changed over quickly and start in the proper position on the belt. An offset adjustment is standard for those times when more strength is required in the weld like on hand railing or off road chassis applications.

    Baileigh Industrial pipe and tube notchers are made of the highest quality standards in the world and will last for decades of profitable service to any demanding fabrication shop.

    Some parts are not legal for use in California or other states with similar laws / regulations