Spring Rate: 217 lbs/in
Moroso designed their trick front coil springs to ''store'' energy for instant, maximum weight transfer for launching. The springs are tall and constructed from small diameter wire to be the correct rate for the particular listed application, although slight trimming may be required to achieve the desired ride height. Sold in pairs. For drag racing only; NOT for street use.Features
Note: To get the desired front end height, it may be necessary to modify the springs. If it is too high it may be lowered by cutting off one-half of a coil Many factors affect the front end height Wheel offset is a major consideration A front wheel offset to the outside will increase leverage of the lower A-frame against the coil spring, and the nose of the car will be lower Disc brake spacers will further affect the height Adding or removing as little as 50 lbs can also make a big difference Take this into consideration when adding a fiberglass hood, aluminum heads, or when putting the battery in the trunk Although these changes will affect the height of the car, the spring rates will be unaffected as long as you stay within the guidelines.
* Other GM-built engines can effect front end weight significantly. Weigh front end to ensure proper spring selection.
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.