Rear Leaf Springs - Ford
*Factory Block Can Be Removed on 4WD to Reduce Lift 2'' on 1980-1986 Models or 3.25'' on1973-1979 Models.
**Factory Block Can Be Removed to Reduce Lift 3.25".
Skyjacker Softride Technology enhances every steely aspect of leaf spring performance, giving you all the vigorous off-road handling needed while providing the smooth street riding characteristics that you demand. Skyjacker Softride leaf springs use only American steel and the individual leafs of each spring are shotpeened with hard steel pellets at very high velocities. This shotpeening compresses the surface of the steel thereby increasing the tensile strength of the spring. Without this shotpeening procedure, the maximum wheel travel and ride quality could not be achieved without sacrificing the life of the spring. Skyjacker Softride Springs use ''bolt'' style spring clips, eliminating friction. Other spring designs use the ''cinch'' style bend clips which bend tightly over the spring leafs causing binding and friction. Skyjacker Softride springs taper over the entire width of the leaf creating more flex at the leaf ends. This tapering distributes loads more evenly over a greater area and reduces the tendency for one leaf to dig into the leaf above it.
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.