Acura/Honda
Outputs | |
Injector Outputs | 12 Saturated |
Coil Outputs | 4 |
Selectable direct drive or 0-5V Coil Output | Yes |
Direct plug in, no jumper harness required | Yes |
General purpose LS outputs | 12 |
General purpose HS outputs | 4 |
Individual cylinder ignition trims | Yes |
Individual cylinder fuel trims | Yes |
Inputs | |
Trigger inputs (Ref/Sync) | 4 |
Analog voltage inputs | 23 |
Configurable Analog/RTD/Thermister inputs | 4 |
Switch inputs | 5 |
Lambda inputs | 2x |
Knock sensors | 2 |
User adjustable knock sensor center frequency | Yes |
Communication | |
USB comms | Yes |
RS232 comms | Yes |
Communication cables included | Yes |
Fully enabled editing/logging software included | Yes |
CAN bus equipped | Yes |
RS232 datastream output | 19 ch |
CAN datastream output | 19 ch |
Communicates with AIM Dash/Dataloggers | Yes |
Communicates with Racepak Dash/Dataloggers | Yes |
DATA Acquisition | |
Internal data logging | 1 MB |
Maximum internal logging rate (per channel) | 250 Hz |
PC logging | Yes |
Data analysis using AEMLog | Yes |
Functions and Features | |
All channels/maps/tuning options unlocked | Yes |
Boost control | Yes |
Groundspeed based boost target | Yes |
Staged injection | Yes |
Ground speed limiting | Yes |
Rate of Acceleration Control | Yes |
Overrun boost enhancement (anti-lag) | Yes |
Gear change ignition cut (shift-without-lift) | Yes |
Password protected calibrations | Yes |
Fuel & Ignition rev limiters | Yes |
"In cockpit" global fuel trim capability | Yes |
Gear dependent shift light | Yes |
Evap/Purge function | Yes |
DC Motor control | 2 Ch |
Software definable "virtual" switch inputs | 2 |
EGT Based fuel trims | Yes |
Maximum boost limit | None |
Physical Dimensions | |
Length | 192 mm |
With | 150 mm |
Height | 37 mm |
Finish | Black Anodized |
AEM Series 2 Plug-N-Play Engine Management Systems | |
- Legal in California only for racing vehicles which may never be used upon a highway. |
This product fits the following vehicles:
Motor Vehicles
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
Tools:
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
Electrical Cords
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.