Free Shipping on Orders Over $95 - Order by 11pm EST for Same-Day Shipping!
Shop By Vehicle
Shop By
All Categories

Gift Certificates
My Account
E-Mail Signup
Catalog Request

Global West CNR-88B

Upper Control Arms Fits GM G-Body Turbo

Part Number: 459-CNR-88B

Upper Control Arms
  • Fits GM G-Body Turbo
  • Brass bushings
  • $665.99
    Ships 11/08/16
    if Ordered Today
    FREE Shipping
    Global West CNR-88B Upper Control Arms Fits GM G-Body Turbo $665.99

    Global West CNR-88B Details

    Upper Control Arms

    For example, 1984-87 Buick Grand National


    Manufacturer's Part Number:

    These arms are designed to change factory suspension pickup points to induce negative camber as the wheel goes up into the fender. The extra negative camber generated by the arms will keep a greater portion of the tire on the ground, which increases the vehicle's cornering ability.


  • Better geometry curve
  • Built-in bump stops
  • Load carrier ball joints
  • Special billet offset shafts

    Installation Notes

  • When using the arms on GM A-bodies, GM tall spindles, machined lower ball joints, and different outer tie rods are required. For 1964-70 A-bodies, use outer tie rod part #459-3007; for 1971-72
    A-bodies, use #459-3008.
  • Negative roll systems will drop the front ride height 1 inch because of the taller spindle and lower ball joint combination. The maximum backspacing on 1964-72 A-bodies is 5-7/8" with a 17" wheel,
    5" with a 16" wheel, and 4-1/2" with a 15" wheel.
  • When using the arms on GM G-bodies, GM tall spindles are required. Spindle tapers for this conversion are the same as the standard, shorter spindle.
  • Factory upper control arms cannot be used with negative roll systems because they are too long, and they won't allow for proper alignment.
  • Factory lower control arms can be used in negative roll systems, but they will require machined lower ball joints (part #459-2005).

  • Items You Need