Free Shipping on Auto Parts Orders Over $75.                           Order by 11 PM EST for Same Day Shipping!

JEGS Performance Products 40223 - JEGS 8.5mm Ultra Pow'r Wires

JEGS Performance Products 40223 - JEGS 8.5mm Ultra Pow'r Wires
JEGS Performance Products 40223 - JEGS 8.5mm Ultra Pow'r Wires

JEGS Part Number: 555-40223

8.5mm Yellow Ultra Pow'r Wires
  • 1985-95 Small Block Chevy Truck 5.0L/5.7L
  • 90° Male Distributor, 90° Plug Terminals
  • Made in the USA
  • Wire Markers
  • Wire Separators
  • Dielectric Grease
    • $41.99 Ships

    JEGS 8.5mm Ultra Pow'r Wires

    Ultra High-Performance Silicone Ignition Wire

    The spiral core design of these spark plug wires begins with a strand of Kevlar® wrapped 57 times per inch, coated first in a stainless alloy and then a conductive polymer latex. Available with a Yellow Jacket and Black Print, Black Jacket and Gold Print, or Red Jacket and Black Print.

  • Greatly exceeds OE specs for RFI and conductivity
  • Spark plug boots and outer jackets are made of high-tear heat-resistant silicone
  • The two outer jacket layers are separated by nylon pull tape for added pull strength & terminal retention
  • Silicone Jacketed to resist high temperature, fuels & oils
  • Stainless steel terminals connected using fold-over crimping that won't vibrate loose like core crimping
  • Wires include wire separators, numbered wire markers, and dielectric grease
  • Sets include coil wire (except where noted)

  • Items similar to JEGS Performance Products 40223

    Rated 5 out of 5 by from Works great -only small issue The wires worked & looked great. Only issue I had, was a similar problem another customer had commented Jegs you might wanna get with whomever makes up your wires at shop. Because they are just not paying attention during ASM . The 90 boot connectors look the same at both ends, however if you pay close attention it (plug boot) will say Distrib- ontop correct boot end, (becuase both ends look exactly same. When the wires are being assembled, they are installing the plug wire boots on both ends, I personally had 2 wires on my order like that. The plug boots theirself may look the same , but they are about 1/4-1/2in to long for the distribuer.So when you try to install, boot hits top of distributer & it will not allow you to snap into place. To avoid waiting any longer, I just took a Razor blade and cut the boot so it would fit. Thats when I notice the writing ontop each boot. There just grabbing boots outta parts bin & not paying attention to detail. Other than that the wires look & work just great, plus a whole lot cheaper than MSD.
    Date published: 2014-11-04
    • 2016-05-26T14:22CST
    • bvseo_cps, prod_bvrr, vn_cps_3.2.1
    • cp_1, bvpage1
    • co_hasreviews, tv_0, tr_1
    • loc_en_US, sid_10001_10001_1042657, PRD, sort_relevancy
    • clientName_jegs
    Items You May Also Consider
    Only $94.81

    Only $41.99

    JEGS Performance Products 80503 - JEGS Spark Plug Gapper
    Only $2.99

    JEGS Performance Products W80578 - JEGS Self-Powered Timing Light
    Only $47.99

    JEGS Performance Products 28020 - JEGS Dielectric Grease
    Only $4.99

    JEGS Performance Products 805010 - JEGS Easy View Spark Plug Indexing Sockets
    Only $14.99

    See All Items You Need