FREE SHIPPING & HANDLING!*                           Order by 11 PM EST for Same Day Shipping!

JEGS Performance Products 40805 - JEGS Mopar Electronic Ignition Control Units & Accessories

JEGS Performance Products 40805 - JEGS Mopar Electronic Ignition Control Units & Accessories

JEGS Performance Products#555-40805

HiRev 7500® Ignition Control Unit
  • Modern Electronics with Mopar OEM Appearance
  • Comparable to Mopar Chrome Ignition Control Unit
  • 7,500 RPM
  • Made in USA

    JEGS Performance Products 40805 - JEGS Mopar Electronic Ignition Control Units & Accessories Details

    Electronic Ignition Control Units

      Installation Notes:
    • Case must be grounded. Be sure mounting location (firewall, bracket, or fender apron) is free of rust & paint (sand or wire brush as required) before mounting Ignition Control Unit. Make sure the mounting screws are tight and use Serrated-head screws or external-tooth lock washers to mount the Ignition Control Unit.
    • Coat connector pins with silicone grease. Be sure wiring connector retaining screw is present and snug.
    • Plugs into all Mopar OEM, JEGS, and Mopar Performance wiring harnesses, whether the harness or vehicle was designed for 4 or 5-pin Ignition Control Units. No modifications required.
    • Use with ballast resister. Works with 2-Pin or 4-Pin ballast resistors. Use without ballast resistor will destroy the Ignition Control Unit.
    • Use with OEM or OEM-Spec (oil filled) ignition coil. E-Frame coils are also acceptable. High Performance Coil 555-40105 is also recommended. Coils made for C-D ignitions (MSD, etc) may destroy the Ignition Control Unit. Coil Primary resistance should be no lower than 1.4?
    • Pre-startup test (recommended for vehicles that has experienced Ignition Control Failure). Connect a voltmeter between the coil positive (+) and a good ground. Turn ignition key to "run" position. Voltmeter should read between 7.0 and 9.0 volts. If higher turn ignition key off immediately and check ballast resister (resistance - too low 0.5? minimum, 1.0? recommended for most street applications), ballast wiring, shorted coil, ignition switch wiring, etc.
    • Quick Wiring Check - Disconnect either ballast connector at idle. Engine should stall instantly.

    JEGS Performance Products 40805 - JEGS Mopar Electronic Ignition Control Units & Accessories

    JEGS offers two options for ignition control on Mopar engines. Choose from the HiRev 7500® control unit with an OEM Appearance & modern electronics inside or the standard Orange control unit. The electrical connector on control unit plugs into all Mopar OEM and Mopar Performance wiring harnesses (both 4 & 5-pin harnesses). A replacement wiring harness and ballast resistor are also available to repair or upgrade the ignition system (sold separately).

    JEGS EZ Kits are designed by JEGS professionals to ensure that you get all the correct parts you need.

    JEGS Performance Products 40105 - JEGS High Energy Ignition Coil
    Only $27.99

    Mopar Performance P4529792 - Mopar Performance Restoration Ignition Wire Sets
    Only $39.99

    Mopar Performance P4529797 - Mopar Performance Restoration Ignition Wire Sets
    Only $39.99

    JEGS Performance Products 10705 - JEGS Crimp Wiring Terminal Connector Kit
    Only $15.99


    See All Items You Need