Free Shipping & Handling on Orders Over $95 - Order by 11pm EST for Same-Day Shipping!
Shop By Vehicle
Shop By
All Categories

Gift Certificates
My Account
E-Mail Signup
Catalog Request

PJ1 SP735

Spray-On Brake Paint Cast Aluminum

PJ1 SP735

Part Number: 322-SP735

Spray-On Brake Paint
  • Cast Aluminum
  • ORMD Item - Ground Shipping Only
    Made In USA
    PJ1 SP735 Spray-On Brake Paint Cast Aluminum $10.99

    PJ1 SP735 Details

  • Features EZ Touch Conical Nozzle
  • Ceramic Resins Resist Heat Up To 900 Deg. F
  • Fast Drying Durable Finish
  • Dry To Touch In 30 Minutes / Handle In 1 Hour
  • Resistant To Chipping/Chemicals/Brake Dust
  • For Use On Brake Calipers/Rotors/Drums

  • Specifications:

    Manufacturer's Part Number:

    Get a Custom Look as You Protect Brake Drums, Calipers & Rotors from Rust, Salt, and Brake Dust


  • 11 oz can
  • Self-priming
  • Protects up to 900° F
  • Durable gloss or satin coating
  • Can be applied to aluminum or cast metals
  • Resists harsh weather, chemicals, chipping, cracking, and fading

    How to Apply
    Prepping Surface
    For maximum adhesion, start with a clean, dry surface. If surface is glossy or rusty, scuff with steel wool or similar pad.

    Masking Area
    To protect from overspray, cover and tape off wheel wells, lugs, floor, and other surrounding areas you do not want painted. However, overspray can be removed with mineral spirits immediately after paint application while surface is still wet.

    Shake can for a full 2 minutes after the agitator ball begins to rattle. Repeat for 10 seconds after each 5 minutes of use. Spray a thin, even coat approximately 8" to 10" away from surface (or experiment with the distance to achieve desired finish). Repeat within 10 to 15 minutes until desired color is achieved. For maximum protection, spray a final coat 5" to 6" away from surface (be careful to avoid running).

    Depending on humidity, paint dries to the touch in 15 to 25 minutes (air dries overnight). For increased heat and chemical resistance, apply heat within 7 days. Curing may also be accomplished due to the inherent heat of operation or in a proper oven.

    Additional Tips

  • Spraying front and rear brake systems will require 2 to 3 cans of paint
  • Test spray a small area before starting the project
  • Apply only when air temperature is 65° F to 95° F
  • Do not apply in high humidity unless parts will be oven cured
  • Apply multiple coats in less than 1 hour OR after 24 hours (coats sprayed between this period may not dry or adhere properly and/or wrinkle)

  • Items You Need