Free Shipping & Handling on Orders Over $75 - Order by 11pm EST for Same-Day Shipping!
0
My Cart
$0.00
Shop By
Category
All Categories

Rebates
Gift Certificates
My Account
Help

Edelbrock 5061K - Edelbrock Torker-II Manifolds and Kits for Chevy



Edelbrock 5061K - Edelbrock Torker-II Manifolds and Kits for Chevy

JEGS Part Number: 350-5061K

Torker II 2-0 Intake Manifold w/Installation Kit
  • Big Block Chevy 396-502ci - Oval Port
  • Square-Bore Carb Flange
  • 2500-6500 RPM Range
  • FREE Shipping
    Easy Kit

    Edelbrock 5061K - Edelbrock Torker-II Manifolds and Kits for Chevy Details

    Chevy 396-502ci Big Block V8

    Designed for street 396-502 c.i.d. Big Block Chevy V8s with large oval-port cylinder heads (1975 & earlier). Will fit under stock hood of Corvette without modification. Manifold not equipped with EGR. Will not fit ''tall block'' V8 engines. Must use manual or electric choke carburetor.

    Installation Notes:
  • Port Size: 1.35/1.60'' width, 1.90'' height
  • Recommended intake gasket; JEGS 555-210102 or Edelbrock 350-7203
  • No EGR provisions
  • Manifold Height: Front 3.050'' (A), Rear 4.600'' (B) (.25'' taller than stock Corvette); Carb Pad Height 3.82''
  • View Manifold ''A/B'' Measurement Guide
  • Carburetor Recommendations: Edelbrock Thunder Series AVS or Performer Series carb, 650-800 cfm
  • 1972-78 applications use 350-8031 throttle cable bracket

    INTAKE MANIFOLD W/ INSTALLATION KIT INCLUDES
    Kit Part Number Intake Manifold Intake Gaskets Intake
    Bolt Kit
    Carb Stud Kit Carb Gasket Silicone
    350-5061K 350-5061 350-7203 555-83205 555-15840 555-16100 555-28030

  • 2500-6500 RPM Power!

    The cast aluminum Edelbrock Torker-II intake manifolds produced for Chevy powered high performance vehicles have a low profile, single plane design that provides adequate throttle response and horsepower gains at high rpm. Since these manifolds are designed with a low carburetor pad height they are ideal on applications with limited hood clearance. These high performance intake manifolds do not have provisions for emissions equipment and should not be used if fuel mileage is a primary concern. The Torker-II design produces tire smoking smiles per gallon!