FREE SHIPPING & HANDLING!*                           Order by 11 PM EST for Same Day Shipping!

JEGS Performance Products 10038 - JEGS Prostarter Starters

JEGS Performance Products 10038 - JEGS Prostarter Starters

JEGS Performance Products#555-10038

GM "R" Terminal Diode Kit

JEGS Performance Products 10038 - JEGS Prostarter Starters Details

Starter Replacement Parts

In GM vehicles originally equipped with a breaker point ignition, the wiring harnesses "R" circuit was a ballast resistor bypass. This terminal is "no connection" when the starter is at rest and is +12VDC while cranking. This circuit provided +12VDC to the ignition coil during cranking for easier engine starting. Cars that do not have a ballast resistor (ie: HEI, MSD or other aftermarket ignition systems) should not need this connection. In most cases this wire will be eliminated. However, cars equipped with a ballast resistor (ie: Breaker Point or Mallory Unilite) may need this harness. If the engine has no ignition during cranking, then the wiring of the coil is going to require an "R" terminal signal. To accomplish this, install an "R" Terminal Diode Kit, part number 555-10038, sold separately.

JEGS Performance Products 10038 - JEGS Prostarter Starters

Prostarter Starters use ball bearings instead of bushings that can wear prematurely. While other vehicle starters offer 3:1 gear reduction, JEGS Prostarters have a Nippondenso motor with a 4.4:1 ratio and cranking power for engines with as much as 12:1 compression.

Features:
  • Weight: 10.5 lbs.
  • Amp Draw: 80 to 90
  • Solenoid housings sealed with O-rings for added protection
  • Full ball bearing construction (instead of bushings) for lasting performance
  • Billet aluminum adapters with 4 adjustable mounting positions for more oil pan or header clearance (except 555-10081 and 555-10085)

    JEGS Prostarter Starters Video

  • Grime Boss A541S30X - Grime Boss Hand Wipes
    Only $9.99

    Grime Boss A544R10X - Grime Boss Hand Wipes
    Only $4.69