FREE SHIPPING & HANDLING!*                           Order by 11 PM EST for Same Day Shipping!

JEGS Performance Products 10038 - JEGS Maxi Prostart'r Starters

JEGS Performance Products 10038 - JEGS Maxi Prostart'r Starters

JEGS Performance Products#555-10038

GM "R" Terminal Diode Kit

JEGS Performance Products 10038 - JEGS Maxi Prostart'r Starters Details

Starter Replacement Parts

In GM vehicles originally equipped with a breaker point ignition, the wiring harnesses "R" circuit was a ballast resistor bypass. This terminal is "no connection" when the starter is at rest and is +12VDC while cranking. This circuit provided +12VDC to the ignition coil during cranking for easier engine starting. Cars that do not have a ballast resistor (ie: HEI, MSD or other aftermarket ignition systems) should not need this connection. In most cases this wire will be eliminated. However, cars equipped with a ballast resistor (ie: Breaker Point or Mallory Unilite) may need this harness. If the engine has no ignition during cranking, then the wiring of the coil is going to require an "R" terminal signal. To accomplish this, install an "R" Terminal Diode Kit, part number 555-10038, sold separately.

JEGS Performance Products 10038 - JEGS Maxi Prostart'r Starters

Perfect for monster compression engines

Weighing only 8.5 pounds, these starters use a 3 horsepower motor (80-90 amp draw) with a 4.41:1 gear reduction to easily crank up to 18:1 compression ratio engines. Features an anodized billet aluminum mounting block with many adjustable positions to accommodate oil pan and header clearances. The starters are powdercoated black with a wrinkle finish and assembled in the USA.

Grime Boss A541S30X - Grime Boss Hand Wipes
Only $8.99

Grime Boss A544R10X - Grime Boss Hand Wipes
Only $4.69

Grime Boss M956S8X - Grime Boss Hand Wipes
Only $14.99