Order Status & Returns
Gift Cards
Help Center
1-800-345-4545
Vehicle Info Needed
Lowest Price GuaranteeBrandACDELCO
Package Height0.8
Package Width3.4
Package Length34.7
Weight0.81 PG
Good Maintenance Practices - Section 2 - Bullet 3Inspection of wheel bearings and grease seals.
Good Maintenance Practices - Section 2 - Bullet 4Parking brake adjustments (as needed).
Fitting MaterialSteel
Programming RequiredNo
End 2 Thread Diameter (Mm)12
Good Maintenance Practices - Section 2 - Bullet 1Inspection of the brake hoses for brittleness or cracking.
Good Maintenance Practices - Section 2 - Bullet 2Inspection of brake lining and pads for wear or contamination by brake fluid or grease.
Good Maintenance Practices - Section 2 - HeaderThe following should be conducted by a qualified technician:
End 2 Flare TypeInverted
Signs Of Wear & Troubleshooting - Section 1 - Bullet 1Brake pedal pulsation (not to be confused with normal ABS operation).
Fitting FinishZinc Aluminum Alloy
Pre-FormedYes
Good Maintenance Practices - Section 1 - Bullet 1Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations.
Teflon LinedNo
Good Maintenance Practices - Section 1 - Bullet 4Check the thickness of your brake pads.
Inside Diameter4.95
Good Maintenance Practices - Section 1 - Bullet 2Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required.
Good Maintenance Practices - Section 1 - Bullet 3Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary).
Features & Benefits - Bullet 2Offering the quality, reliability, and durability of GM OE
Features & Benefits - Bullet 3Manufactured with GM Original Equipment specification for fit, form, and function
Fitting TypeFlare
Outer Wear GuardNo
Product DescriptionACDelco GM Original Equipment Brake Hydraulic Lines are quality reinforced lines that carry fluid within the brake system, and are GM-recommended replacements for your vehicle's original components. The hydraulic fluid must travel to the wheel brakes from the master cylinder. It does this through brake lines or pipes and brake hoses. Brake lines and hoses are designed to withstand high pressures, and these brake hydraulic lines have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors. ⚠<b> WARNING:</b> Cancer and Reproductive Harm - www.P65Warnings.ca.gov
End 1 Thread Diameter (In)0.43
Features &#38; Benefits - Bullet 1GM-recommended replacement part for your GM vehicle's original factory component
End 1 Thread Diameter (Mm)11
End 1 Flare TypeBubble
Volume (Cu In)42.18cu in
Good Maintenance Practices - Section 1 - HeaderThe following inspections and maintenance procedures can help prevent potential brake problems.
Width (In)10.35
Polyvinyl Fluoride CoatedNo
Flange Width (In)0.19
Line MaterialSteel
Line Length821.61
Height (In)0.8
Signs Of Wear &#38; Troubleshooting - Section 1 - Bullet 2Vehicle pulls to the left or right when brakes are applied.
BendableNo
Length (In)12.95
End 2 Thread Diameter (In)0.47
Line Diameter0.19
Outside Diameter6.87
Outer SpringNo
Weight (Lb)0.22
Grade TypeOE
Vendor Part Number84751604
Package Qty1
Package TypeEA
No Questions
No Reviews
Some parts are not legal for use in California or other states with similar laws / regulations
