Water/methanol injection cools the intake charge and helps suppress detonation, so a boosted gas engine can hold more boost and timing on the fuel it already runs. This V3 kit pairs a standard boost dependent controller, rated to 35 psi, with a 1.15 gallon reservoir so it is ready to plumb into a turbocharged or supercharged build.

AEM 30-3300 Kit Contents:

• Standard controller has an on-board MAP sensor with a molded-in nipple for the boost hose and is rated up to 35 psi.
• The reservoir has a built-in conductive low fluid level indicator.
• Three interchangeable injector nozzles cover a wide range of power levels: 250, 500 and 1000 cc/min.
• Terminated harness has a positive lock connector, an integrated pump ground circuit and an extra wire for an optional on/off flow solenoid.
• Includes a Boost Safe readiness failsafe system.
• One machined billet injector with an integral check valve prevents unintended flow.
• A recirculation-style pump with integral fittings runs quietly.
• An LED dash light shows system status and low fluid warnings.
• Includes 20 ft. of high-pressure nylon injection tubing.
• Controller has large adjustment knobs, a covered status LED and test button for splash resistance, an integrated fuse and mounting tabs.