Notes:

• VIN Y
• Head Cast #: 1.6L
• Block Cast #: 4G61, G4CR
• Water pump, timing gears, belt, and tensioner installed
• 16 valves

Engine Break-In Procedure

Use conventional or break-in oil (non-synthetic) for the first 600 miles of operation. Do not drive for long periods at any single speed, always vary your speed. Do not tow a trailer or put other heavy loads on the vehicle. Check the engine oil and coolant levels daily. 

At 600 Miles change the engine oil and filter using conventional (non-synthetic) oil. Check fuel and ignition settings; adjust valves (where applicable).

After the first 5,000 of service synthetic engine oil may be used. Follow your vehicle owner’s manual for service intervals.

Please CLICK HERE for ATK Warranty