Chassis Engineering ES-1124 Features:

ES-1124 Transmission Crossmember for 1937-1939 Chevy with Turbo 350

Bolt in for use with transmission described below. Required for power brakes but can also be used with a manual brake system.

This kit Includes:

Removable bolts
Instructions
Crossmember
Turbo 350, powerglide, standard transmissions or any transmission that measures 20 5/8 in. from engine to transmission mounting holes.

Installation Instructions:

Universal Transmission Mount For Chevrolet Turbo 350 3&4 Speed Manual for 1937-1939 Chevy Car.

Use Chassis Engineering Transmission Cushion Set SS-0112

Step 1. Install the transmission crossmember on your Chevy frame. Measure from the inside of the frame at the rivet for the running board brace to get the 3/4 in. measurement

Step 2. Clamp the transmission mount in place, then locate and drill the holes.

Step 3. Bolt the support rods to the back of the crossmember, bolt support-rods to the crossmember first.

Step 4. Swing the support rods to the side of the frame. Center the support rod mounting pads under the frame rail and clamp them in place. Now drill the holes and bolt them to the bottom of the frame.