Ford Racing Engine Block
• 1.6L Kent 4-Cylinder
• 8.200" Deck Height w/ Extra Material
• 3.185" to 3.187" Semi-Finished Cylinder Bores
• .5145" to .5155" Lifter Bore Diameter
  
  

  The legendary Formula Ford Kent block is reborn with an all new iron casting that is stronger than the original! The block was designed to replace production 1.6L Kent blocks for SCCA Formula Ford competition. WARNING: This part is designed and intended for competition use only. It should not be installed on a vehicle that is driven on public roads and highways. Installation of this art on a vehicle driven on public roads and highways is likely to violate U.S. and Canadian laws and regulations relating to motor vehicle emissions.

• Standard 8.200 in. Deck Height w/Extra Material For Decking
• Cylinder Bores Semi-Finished To 3.185 - 3.187 in. Dia.
• Max Bore Size 3.226-inch / 81.94mm
• Lifter Bore Dia. 0.5155-0.5145 in.
• Block Case from 40000 PSI Gray Iron
• Lower Clutch Housing Bolt Bosses Reinforced
• Select Areas Around Main Bearing Webs Strengthened
• Center Main Accepts Upper/Lower Crankshaft Thrust Bearing Inserts

Emissions Note:

This part is only legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles or on vehicles used solely for the purposes of closed competition racing.

CLICK THIS LINK FOR IMPORTANT CARB & EPA EMISSIONS INFORMATION ABOUT THIS PART