Order Status & Returns
Gift Cards
Help Center
1-800-345-4545
Vehicle Info NeededLower Front Control Arm Bushing Kit Fits GM Applications
Ships on 09/14/2026
Lowest Price Guarantee- Lower Front Control Arm Bushing Kit
- Fits GM Applications
Fits: - 1975-79 Buick Apollo
- 1985-96 Buick Electra RWD
- 1985-96 Buick Le Sabre RWD
- 1985-96 Buick Roadmaster RWD
- 1973-77 Buick Century/Regal/Grand National
- 1985-96 Cadillac Fleetwood/Brougham
- 1977-84 All Cadillacs except Eldorado/Cimaron/Seville
- 1976-79 Cadillac Seville RWD
- 1971-92 Chevy Belair/Biscayne
- 1974-81 Chevy Camaro
- 1971-92 Chevy Caprice
- 1973-77 Chevy Chevelle/El Camino/Malibu/Monte Carlo
- 1971-96 Chevy Impala
- 1975-79 Chevy Nova
- 1971-92 Oldsmobile Delta 88
- 1973-77 Oldsmobile Cutlass/442
- 1975-79 Oldsmobile Omega
- 1971-81 Pontiac Bonneville/Catalina/Grandville
- 1974-81 Pontiac Firebird
- 1973-77 Pontiac GTO/Lemans/Tempest/Grand Prix
Del-A-Lum Bushings are a direct replacement for rubber or polyurethane control arm bushings. They are perfect for street or race applications. Del-A-Lum bushings feature inner and outer thrust washers, inner rotating sleeve, and lube fittings. This unique design provides smooth performance without squeaks or bind. Designed to last over 100,000 miles, Del-A-Lum bushings on the street or at the track will give you optimum performance and control.
Show More
Del-A-Lum Bushings Features and Benefits:
- Zero deflection fore and aft
- Perfect for street and race applications
- Smooth movement up and down
- Easy press-in installation for most applications
- Directly replaces factory bushings
- Fully greasable
- Low maintenance
- Quiet, will not squeak
- Limited Lifetime Warranty
Offset Shafts can be used in the factory upper control arms and take the place of stock shafts. Offset shafts generally give you about 1-1/4 degree change. All shafts are made out of billet steel and are supplied with hardware for the shaft, but not for the frame. Standard non-offset shafts are also available and are highly recommended if you are using Del-A-Lum or polyurethane bushings. The shafts are made to accommodate 5/8'' fine threaded locking nuts rather than a factory shaft that uses a 3/8'' bolt holding the bushing in place.
Offset Shaft Features and Benefits: - Improved general alignment applications. Performance alignment setting is far easier to obtain with offset shafts. The shaft allows caster to be added without losing proper camber settings.
- Correcting alignment for frame sag or for frames that have been damaged.
- Obtaining specified alignment using tubular control arms.
