Holley 12-168

Breakdown of Included Items

Features:

• Installs in most 7 in. to 12 in. deep factory fuel tanks or fuel cells to convert to an in-tank EFI fuel system
• Ideal for Terminator EFI, Sniper EFI, MSD Atomic EFI, or any TBI EFI conversion
• Horsepower ratings @ 60 PSI at 13.5 V / 16.9 AMP draw
• The mounting surface is only 1.275 in. thick for a low-profile design and added clearance
• An innovative clamping system for locating the module anywhere in the tank beside the existing sending unit
• 360-degree rotating for easier clocking of the plumbing and wiring locations
• The die-cast hanger bracket controls pump vibration

Notes:

• For installation, it is recommended to use a Holley 510-12-753 30 Amp Fuel Pump Relay and 12-gauge wire minimum size
• Use only a maximum size of 6 AN for lines and fittings due to space limitations between unit and fuel tank

Emissions:

This part is legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles and Racing Use Only Vehicles.

The following vehicles are considered Uncontrolled (Non-Emissions Controlled) Vehicles:

• 1965 and older U.S. manufactured California Certified vehicles
• 1967 and older U.S. manufactured Federally Certified vehicles
• 1967 and older Foreign manufactured vehicle

The following vehicles are considered Racing Use Only Vehicles:

• Vehicles that are used exclusively for competition and that are not registered and that may never be used on the street