Holley 320-322 Features:

These Holley steering shaft kits were designed to replace a worn stock one on your early 3rd generation GM C10 trucks or with an engine swap where additional clearance may be needed. With sturdy DD-style steel shafts and dual u-joints, there is plenty of adjustability for your project to ensure everything is exact and safe.

• Complete bolt-on solution with little or no modifications necessary depending on use
• Eliminates factory rag joint providing a precise and responsive steering input
• Will also work as a factory replacement steering shaft
• E-Coat for maximum protection against corrosion
• Steel construction with retaining screws on the bearing caps for strength and durability
• It is extremely important that these steering shafts are installed by a qualified technician. Failing to do so will result in an unsafe vehicle
• If installing these shafts with an OE steering box, you may need to trim the pin on the input shaft for U-joint clearance
• Loctite 242, extra grease, and a torque wrench are highly recommended
• Material: Steel
• Color: Black
• Mounting Hardware Included: Yes
• Finish: Black E-Coat
• End 1 Type: DD
• End 2 Type: DD
• Universal Joints Included: Yes
• Grade Type: Performance
• Application: 1973-1978 GM C10 Trucks
• Brand: Holley
• Dust Boot Included: Yes
• Product Type: Steering Shafts
• Shaft Diameter: 1 in. DD
• Shaft End 1: 3/4 in. 30-Spline x 3/4 in. DD
• Shaft End 2: 1 in. 48-Spline x 1 in. DD
• Shaft Length 1: 3/4 in. DD x 10.75 in. Long
• Shaft Length 2: 1 in. DD x 10.75 in. Long