Some supported Honda platforms use a 4-pin diagnostic connector rather than the standard 16-pin OBD-2 layout, and the HP Tuners H-002-11 is built to bridge that gap. It terminates in a 4-pin connector matched to the vehicle end while presenting a standard OBD-2 connection to the HP Tuners interface, giving tuners the physical link needed to read and write calibrations on these applications.

HP Tuners H-002-11 Compatibility Notes:

• Terminates in a 4-pin connector matched to supported Honda diagnostic ports.
• Presents a standard OBD-2 connector on the interface end for use with HP Tuners MPVI-series devices.
• Functions as a direct replacement for a worn, damaged, or missing factory cable.

Emissions Disclaimer

HP Tuners designs and manufactures software and hardware tools for vehicle diagnostics, scanning, logging, calibration, and data acquisition purposes. The authorized use of such tools is to bring a motor vehicle into emissions compliance and/or to maintain emissions compliance, as well as for use on competition/racing and other exempted vehicles. HP Tuners does not create or provide tunes or pre-made calibrations.

HP Tuners' Terms of Use, policies, and agreements mandate that users shall comply with all local, state, and federal laws. In using HP Tuners software and hardware tools, you are representing, warranting, and agreeing not to use, employ or allow any HP Tuners tools to operate as a defeat device or to violate emissions compliance in any manner whatsoever. You further represent warrant and agree that the HP Tuners tools shall only be used by manufacturers, calibration businesses, and professionals to develop emissions-compliant and/or exempted calibrations.

Emissions Note:

This part is only legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles or on vehicles used solely for the purposes of closed competition racing.

CLICK THIS LINK FOR IMPORTANT CARB & EPA EMISSIONS INFORMATION ABOUT THIS PART