JEGS 555-70225 Stationary Pedestal Seat Mount Features:

• Includes four brackets, four bolts, washers, and nuts, to mount one seat in a vehicle
• Made in the USA with high-quality components and assembly
• Tilt adjustment design by pre-drilled holes and using included hardware to set the angle needed
• Universal fitment is designed to fit with or without modification to both the seat being used and the floor being mounted to; holes are not drilled and hardware is not provided to connect the mount to the seat and floor
• Saves time having to fabricate your mounts

• Mounting Hardware: 1/4 in. -28
• Prevailing torque nuts are single-use lock nuts
• Cannot use lowest mounting holes when in a C-orientation
• Assembled heights:
  • Minimum (Z-orientation): 2 in.
  • Minimum (C-orientation): 2 1/2 in.
  • Maximum (Both orientations): 3 in.
• Tilt and height adjustments: 1/2 in. increments

Make assembling your interior easy with the stationary pedestal seat mount from JEGS. The pre-drilled holes let you determine the height and angle. To allow for universal fitment holes are not drilled for the seat or floor mount. The included hardware is for bracket assembly only. Additional hardware will be necessary for installation. Make sure to measure the distance between mounting holes to ensure they fit the 13 in. long by 2 in. wide bracket. This kit is for 1 seat. 

Note: Holes must be drilled for installation. Brackets may not be returned once holes have been drilled in them.