The JEGS 555-80376 electric winch delivers 2,500 lb of rated single-line pull for ATVs, UTVs and side-by-sides. It is sized for riders who need self-recovery capability in mud, sand and off-camber terrain without carrying the weight of a full-size truck winch, and it doubles as a stationary pulling winch for loading equipment or a non-running machine onto a trailer or into a truck bed. A 1.1 HP permanent magnet 12-volt motor turns a 153:1 differential planetary gearset, and the free-spool clutch knob lets you pull cable off the drum by hand instead of powering it out.

JEGS 555-80376 2,500 lb ATV and Utility Winch Features:

• Fits ATVs, UTVs and side-by-sides, and doubles as a stationary pulling winch for trailer loading
• 2,500 lb rated single-line pull, measured on the first cable layer on the drum
• 1.1 HP permanent magnet 12V DC motor built for intermittent recovery duty
• 153:1 differential planetary gearing holds line speed controlled under load
• Automatic spring brake holds the load in place when the winch stops pulling
• Line speed of 10 FPM with no load and 2.6 FPM at the full 2,500 lb rated pull
• Motor current draw of 12 amps with no load and 120 amps at rated pull
• 3/16 in. x 41 ft. steel wire rope on a 1.25 in. x 2.86 in. drum
• Included roller fairlead rolls with the steel cable to cut friction and wear as it feeds on and off the drum
• Free-spool clutch lets you pull the cable off the drum by hand without drawing battery current
• Powered in and powered out operation reels the cable in or out under motor control, even under load
• Sealed gearbox is pre-lubricated with high-temperature lithium grease and needs no internal service
• IP55 rated, dust-protected and water-jet resistant
• 4-hole 4.87 in. x 3 in. mounting bolt pattern is the standard for this class of ATV and side-by-side winch, so most common mounting kits bolt up
• Compact 11.8 in. L x 4.15 in. W x 4.15 in. H housing fits tight ATV and UTV mounting areas
• Net weight of 15.4 lb

JEGS 555-80376 2,500 lb ATV and Utility Winch Notes:

• Installs with M8 hardware and must be mounted on a flat surface so the motor, drum and gear housing stay in alignment
• Requires a 12-volt vehicle electrical system; keep the engine running during use to minimize battery drain
• Bumper and snatch block sold separately

JEGS 555-80376 2,500 lb ATV and Utility Winch Includes:

• (1) 2,500 lb electric winch assembly with 3/16 in. x 41 ft. steel wire rope
• (1) Mounting plate
• (1) Roller fairlead
• (1) Clevis hook
• (1) Hook strap
• (1) Wireless remote control
• (1) Wired controller with 9 ft. cable
• (1) Handlebar mount for the wired rocker control switch
• (1) Control module
• (2) Battery leads
• (4) Terminal insulators
• (1) Clutch knob
• (2) Mounting clamps