This version of the Moroso carburetor stud kit is sized for engines running a thin carburetor spacer that still need a solid throttle return spring anchor. It pairs a 0.250 in. thick bracket with two stud lengths, so the spacer height and the extra bracket thickness are both accounted for instead of being absorbed by whatever bolt is on the shelf. Studs also make the carburetor easier to set down squarely on a spacer and two gaskets without shifting.

Moroso 37967 Kit Contents:

• Two 5/16-24 x 2.0 in. studs and two 5/16-24 x 2.5 in. studs.
• 0.250 in. thick throttle return spring bracket mounts under the longer stud pair.
• 12-point nuts clear the carburetor body where hex nuts often will not.
• Hardened flat washers included for even clamp load on the flange.
• Black oxide finish resists fuel and moisture exposure.

Note: check that the bracket does not contact the linkage arm at wide open throttle before final torque.