OER T1462 Features:

Exact reproduction of the original factory molding clip as found on 1962-66 Chevrolet and GMC trucks. Each metal clip is manufactured in steel, and comes with seal that seals the molding hole to prevent water and other elements from entering into the interior of the panel. Great care has been taken to duplicate the original clip to ensure a superior molding installation job, and deliver a result that is just like the GM factory intended for it to be done. This is the larger of the two square wire clips used on the upper molding on 1962-66 Chevy truck models with body side molding. Measures 1 1/4" tall x 1 1/8" wide. Sold individually. Pickup Truck Short Bed Useage; 36 clips are required to do both sides on Chevrolet or GMC short bed models Each side requires a total of 18 clips. 1 clip at the back of each fender 6 clips on each door 11 clips on each bed side on short bed models 36 clips are required to do both sides on Chevrolet or GMC short bed models Each side requires a total of 18 clips. 1 clip at the back of each fender 6 clips on each door 11 clips on each bed side on short bed models Pickup Truck Long Bed Useage; 40 clips are required to do both sides on Chevrolet or GMC long bed models Each side requires a total of 18 clips. 1 clip at the back of each fender 6 clips on each door 13 clips on each bed side on long bed models 40 clips are required to do both sides on Chevrolet or GMC long bed models Each side requires a total of 18 clips. 1 clip at the back of each fender 6 clips on each door 13 clips on each bed side on long bed models Additional Information Note: Measurements: 1-1/4" tall x 1-1/8" wide Note: Measurements: 1-1/4" tall x 1-1/8" wide Note: