Trail-Gear 304695-KIT Power Flow Power Steering Pump Rebuild Kit

Trail-Gear Power Flow steering pumps used in racing, rock crawling and off-road applications undergo way more stress than those used under normal conditions. However long it takes, eventually your Power Flow pump may be out of warranty and need to be rebuilt. More often than not, a properly rebuilt steering pump will be as good as new after replacing the wear components. Trail-Gear’s Power Flow Steering Pump Rebuild Kit contains all of the internal wear components needed to rebuild any of our Power Flow PS steering pumps and get you back on the trail. With Trail-Gear’s step by step instructions, rebuilding the pump is simple.

Trail-Gear 304695-KIT Power Flow Power Steering Pump Rebuild Kit Includes:

• Pressure Plate
• Thrust Plate
• Rotor
• Vanes
• Snap Ring
• Alignment Pins
• C-Clip

Trail-Gear 304695-KIT Power Flow Power Steering Pump Rebuild Kit Notes:

• For Genuine Trail-Gear Power Flow 1650 psi Power Steering Pumps Only!
• To verify that your pump is a genuine Power Flow Power Steering Pump, look for the markings on the end of the pump Cap.
• This kit is designed for these Power Flow Pumps: 130304-1-KIT - Power Flow PS Pump with V-Belt Pulley, 300154-1-KIT - Power Flow PS Pump with Serpentine Pulley, and 130303-KIT - Power Flow PS Pump without Pulley