Free Shipping on Auto Parts Orders Over $75.                           Order by 11 PM EST for Same Day Shipping!

Paxton 1001864SL - Paxton Supercharger Systems 1964-69 Mustang

Paxton 1001864SL - Paxton Supercharger Systems 1964-69 Mustang
Paxton 1001864SL - Paxton Supercharger Systems 1964-69 Mustang
Representative Image
Product images may differ from actual product appearance.

JEGS Part Number: 769-1001864SL

NOVI 1200SL PowerHat Supercharger System
  • 1964-68 Mustang (Passenger Side Mount)
  • Small Block Ford 260/289/302 Carbureted
  • Satin Finish

    Paxton 1001864SL Details

    1964-68 Mustang

  • Passenger Side Mount
  • PowerHat Carburetor Assembly

    This entry-level PowerHat System produces horsepower gains that range from 30% to 75% based on boost level and the engine's volumetric efficiency. It can be used on many existing OE drive configurations with or without power steering. The system can also be upgraded with optional parts for additional power (suggestions below). The PowerHat Carburetor Bonnet applies diffusion technology for maximum power output. An integrated air management diffuser element minimizes the jetting/tuning issues associated with traditional "carb hats." The design permits a near-360-degree rotation for universal fit, and the 3.2" low-profile height provides ample hood clearance.

    Included Components
  • NOVI 1200SL Supercharger (3.7" drive)
  • Billet aluminum 8-rib supercharger crank pulley with hard anodized finish (6.88" diameter)
  • Integrated manual belt tensioner with sealed bearing tensioner pulley and 8-rib belt
  • Billet aluminum mounting bracket & hardware with provision for alternator mount
  • Supercharger air inlet filter
  • Aluminum discharge tube with clamps and silicon sleeves
  • Cast aluminum PowerHat Carburetor Bonnet Assembly (3" inlet port)
  • Sealing gaskets and necessary mounting hardware for attachment to 4150-type 4-barrel carburetor

  • Maximum Ratings: 775 HP/52,000 RPM/22 psi/1,150 cfm
  • 4 to 10 hours to install depending on application
  • 1967-68 Mustang may require relocation of the battery
  • Power steering and alternator can be retained (Generators must be replaced)
  • No CARB EO Numbers apply (California Air Resources Board Executive Order)
  • Preset pulley ratio will produce about 6-8 psi at 5500 RPM on a mildly modified 289 engine
  • The included discharge tube accommodates many intake manifold heights, but high-rise manifolds may require modification for best fit

    Required Components (Not Included)
  • Quick Fuel, Demon, or Holley 4150-type 4-bbl carb with mechanical secondaries designed for ''blow-through'' applications (Rejetting may be required; #793-Q-750-BAN recommended for most applications)
  • High-volume boost-referenced fuel pump
  • Compressor bypass valve for all applications exceeding 5 psi boost (From Paxton: #769-8D204-001, #769-8D103-001, or #769-8D205-003)
  • Accessory belts (Varies per application based on accessory configuration and supercharger pulley diameters)

    Recommended Components
  • Aluminum Bypass Weld-On Flange: #933-8D004-052, #933-8D003-052, or #933-8D005-051
  • MSD 6A Ignition Amplifier Box or equivalent

  • Paxton Supercharger Systems 1964-69 Mustang

    As a tribute to the Paxton supercharged Shelby GT-350 of the 1960s, Paxton offers current systems for Ford Mustang carbureted V8s. With HP gains ranging from 30% to 75% depending on engine build, the NOVI 1200 or 1500 nearly silent, gear-driven supercharger will yield street superiority.

  • Designed to fit under stock hoods
  • Required belts and pulleys for use in V-belt setup
  • Aluminum discharge tube with Bosch compressor bypass valve
  • Billet aluminum mounting plate for alternator and supercharger drive assembly
  • Optional PowerHat Carburetor Assembly (details in More Info with applicable part numbers)
  • Linkage arms, splined shaft, and left/right spherical rod ends for simple throttle connection & adjustment

    NOVI Supercharger
    Paxton Automotive NOVI Superchargers offer the ultimate in performance and reliability from a centrifugal supercharger. Based on Paxton's race-proven gear case, NOVI Superchargers use helical-cut billet steel gears (for quiet operation) and aerospace-quality high-speed bearings. A direct-to-gear, constant oiling system provides optimum lubrication and cooling even under sustained boost. Some of today's fastest race cars run NOVI Superchargers, a testament to their unsurpassed performance in the most demanding situations.

    NOVI SL Supercharger
    The NOVI SL (Self-Lubricating) Supercharger has an internal oil reservoir for self-contained lubrication so no oil lines are needed, and a unique transmission housing enables effective gear lubrication and bearing temperature control.

  • Gear case baffling for proper oil control
  • No connection required between engine oil pan & compressor or gear case
  • Simple oil slinger design does not require a separate shaft or bearing set
  • Supercharger is prefilled with Paxton's special synthetic fluid
  • Integrated dipstick for easy fluid checks
  • Remote drain hose for oil change without removing supercharger from car
  • Can utilize any existing NOVI bracketry (1200, 1220, 1500, or 2200)

  • Two Configurations
  • Passenger Side Mount (allows use of factory power steering)
  • Driver Side Mount (requires an alternator in place of a generator where applicable)

    Tech Notes
  • Not compatible with generator-equipped vehicles
  • Included air filter may interfere with some valve covers
  • Carburetor enclosure is compatible with small diameter distributor cap only
  • Throttle linkage compatible with 1964-68 Mustang only (other years/vehicles will need custom throttle linkage construction)
  • Stock compression ratio is recommended. If other than the factory manifold (standard rise) is used, a cowl hood may be needed.

    Air Conditioning
    For 1964-68 Mustang 260/289/302 with passenger mount configuration, factory air conditioning can be used by adding an optional A/C assembly (Paxton part number 4PFX110-080). For the 1969 Mustang 351 Windsor with passenger mount, most vehicles incorporate an A/C belt tensioner on the compressor support plate. In such cases, a water pump pulley and proper length A/C drive belt must be obtained.

    Both applications utilize the 1965 Mustang (York-style) compressor support, pulley diameters, and offsets. This allows the alternator, power steering, and A/C compressor to be retained; if equipped, however, the smog pump must be eliminated.

    Air/Water Charge Cooler Upgrade
    Includes charge air cooler core assembly, water storage tank, compact water circulation pump, large water cooler, and radiator mounting kit (Paxton part number 8PN301-080 with satin finish or 8PN301-088 polished). Compatible with #769-1001840SL, #769-1001840SLP, #769-1001847, and #769-1001847P.

  • Paxton 1001864SL

    Fuel Injectors Included
    Filter Included
    Blower Pressure (psi)
    Bypass Valve Included
    Carburetor Flange
    Square bore
    Computer Chip/Programmer Included
    Electric Fans Included
    FMU Included
    Fuel Pump Included
    Intercooler Included
    Sold as a kit
    Supercharger Finish
    Supercharger Model
    Manufacturer's Part Number:
    Rated 5 out of 5 by from beautifully crafted....from the creators of boost If your looking for the cheapest way to boost your carbureted small block ford this kit will do it. Just ran an electric water pump and went with a manual steering rack eliminating the power steering pump. That just left the alternator which mounts off the supplied bracket and the kit has the crank pulley. The kit was just missing a few items easily found here at jegs. I am really happy with my purchase. Try getting up to 22lbs. of boost from any other manufacturers for less than $3,000. But... Plan on a wait because it could take a few weeks to get one of these.
    Date published: 2016-02-08
    • 2016-05-29T10:00CST
    • bvseo_cps, prod_bvrr, vn_cps_3.2.1
    • cp_1, bvpage1
    • co_hasreviews, tv_0, tr_1
    • loc_en_US, sid_10001_10001_1524607, PRD, sort_relevancy
    • clientName_jegs
    Grime Boss A541S30X - Grime Boss Hand Wipes
    Only $4.99

    Grime Boss A544R10X - Grime Boss Hand Wipes
    Only $2.69