Flange Yokes 1310 Series
I am putting an 8.8 rear end out of a 1997 Ford Explorer into my 1986 Ford Ranger 4X4 extended cab 2.9 V6. I cannot find a definite answer for whether or not the factory U-joint at the rear axle on my 86 Ranger is the 1310. Is this the part I need?
Will this work with your turbo 350 driveshaft to bolt the joint on a ford 9” rear?
Will this bolt to 8.8 from 1996 explorer?
Will this fit a 89 lincoln mark vii Lsc
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.