Items You Need
Crate Engines
Engine Specifications
2018-2020 Ford Mustang GT 5.0L Coyote Gen III crate engine with Twin Independent Variable Camshaft Timing (Ti-VCT)
- Horsepower: 460 hp at 7,000 RPM
- Torque: 420 ft-lbs. at 4,600 RPM
- Maximum RPM of 7,500
Block Information:
- Aluminum block with plasma transferred wire arc spray weld liner coating
- Cross-bolted main bearing caps and thick main bearing bulkheads for strength
- Optimized oil drain-back and windage control for improved high-rpm performance
- Long 12 mm head bolts for higher clamp load
- Bore/Stroke: 93 mm x 92.700 mm
Rotating Assembly:
- Crankshaft: Forged steel cross-plane
- Rods: Sintered steel 150.700 mm length, 618 g weight
- Compression Ratio: 12.0:1
- Pistons: Hypereutectic raised dome 8.411 cc
Cylinder Head:
- High-flow AS7GU aluminum
- DOHC 32-valve with variable intake and exhaust cam timing
- Valve Size: 37.700 mm Intake / 32 mm Exhaust
- Valve Lift: 14 mm Intake & Exhaust
Fuel Injection
- Dual, direct and port injection
Intake Manifold
- Tuned composite
- Variable runner control
- 80 mm electronic throttle body (Drive-by-wire)
Oil Pan:
- Oil Pan: Composite 10 qt capacity w/filter
Notes:
- Includes manual transmission engine harness and flywheel
- Mustang GT 409 stainless-steel tubular exhaust manifold on the RIGHT SIDE ONLY
- Engine mount bosses and bell housing mount pattern common to 4.6L modular engines
- Vehicle harness and PCM not included
- M-6017-M50B Control Pack includes wiring harness, PCM and designed for installation kit for project vehicles
- Alternator not included, for alternator kit use M-8600-M50BALT
- Engine weight: 425 lbs. without accessories
Engine Break-In Procedure
Fill the engine with 5W50 full synthetic engine oil. For the first 500 miles of operation do not drive for long periods at any single speed, always vary your speed. Do not tow a trailer or put other heavy loads on the vehicle. Check the engine oil and coolant levels daily. At 500 Miles change the engine oil and filter. Check fuel and ignition settings; adjust valves (where applicable).
Specifications:
Will this this work in a 2015 F150 w existing 5.0
Will this engine fit a 2021 ford bronco
Does this engine fit a 2012 mustang v6 plan on swapping it to a 5.0
Will this engine fit in a 2004 mustang
Will this fit in a 1987 mustang gt?
Does this run on 93 octane?
Will this fit into a 2002 mustang GT to the existing 5 speed transmission?
Will this engine fit in a 99 Ford explorer?
Motor Vehicles
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
Tools:
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
Electrical Cords
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.