G-FORCE Racing Gear is the only manufacturer to use 3-inch wide bolt end hardware pieces instead of the 2-inch standard pieces that all other manufacturers use. At the point of failure a 3-inch wide bolt end will withstand almost 2000-pounds more before failure than a 2-inch wide bolt end piece.

H-Type Harness: Shoulder: 26" - 80", Pull-Down: 38" - 67", Pull-Up: 38" - 80", Sub-Strap: 7" - 25"

5-Point Individual	6-Point Individual
Adjustment Lengths: Lap: Pull-Down 38'' to 67'' / Pull-Up 38'' to 80'' Shoulder: 26'' to 50'' Sub-Strap: 7'' to 25''	Adjustment Lengths: Lap: Pull-Down 38'' to 67'' / Pull-Up 38'' to 80'' Shoulder: 26'' to 50'' Sub-Strap: 7'' to 25''

G-Force Harness Installation Instructions

Note: ''Pull-Up Lap Belt Adjusters'' & ''Pull-Down Lap Belt Adjusters'' indicates the direction that tightens the Lap belt adjuster's. For example, a ''Pull-Up Lap Belt Adjuster'' is always the best choice in a Dragster. It is much easier, and safer, to tighten your belts in an upward motion (towards the Camlock latch) rather than a downward motion (away from the Camlock latch) because of the limited cockpit room. JEGS Easy Kits are designed by JEGS professionals so you get all the parts you need.