
GM Small Block Gen 5 LT1 Atomic AirForce Red Logo Intake Manifold
Features:
- 50 State Legal EO# D-722-3
- Developed using Computational Fluid Dynamic Modeling to maximize plenum volume and air flow efficiency
- Made from high-heat resistant, lightweight polymer
- Allows the use of stock or aftermarket fuel rails
Emissions Note:
This part is legal for sale and use on Emissions Controlled Vehicles, in all 50 states, when used in accordance with the manufacturer's application guide because it has a California Air Resources Board (CARB) Executive Order (EO) number # D-722-3.
CLICK THIS LINK FOR IMPORTANT CARB & EPA EMISSIONS INFORMATION ABOUT THIS PART
Increased Airflow and Distribution
MSD's Atomic AirForce Intake Manifolds increase airflow and distribution for improved performance on both stock and modified engines. The 2-piece polymer-molded design of the bell-mouthed runner entrances allows easy access to the runners for porting. These intakes accept an OE or 103mm throttle body and stock, aftermarket, or Atomic LS EFI fuel rails. Atomic AirForce Intake Manifolds include new gaskets and hardware for easy bolt-on installation.






