Push-Pull Battery Disconnect Switches
- Single Pole, Two Positions: Off-On; Disconnects battery circuit only.
- Push-Pull Rod Assembly for easy shut down
- UL listed: Not listed
- Switch Rating: 6-36 V DC; 300 amp continuous, 2000 amp intermittent 30 sec. On, 3 min. Off
- Switch Terminals: (2) 1/2 in.-20 thread copper studs
- Switch Actuator: Aluminum Single Throw lever with Push-Pull Rod
- Switch Mounting Stem: Brass, 3/4 in.-16 thread, 23/32 in. long, fits supplied mounting bracket
- Switch Contacts: Copper
- Switch Case: Plated steel
- Installation: L Mounting Bracket can be located almost anywhere
- (1) Disconnect Switch
- (1) Push-Pull Rod : 17 7/8 in. L x 1/2 in. O.D. with 1/4 in.-20 & 1/4 in.-28 threaded ends
- (1) Rod End: 1/4 in.-28 thread & 1/4 in. I.D. mounting hole
- (1) Set Screw: 1 in. L x 1/4 in.-28 thread
- (1) 1/4 in.-28 thread nut
- (1) 1/4 in.-20 thread nut
- (1) 1/4 in.-20 thread nyloc nut
- (1) 1/4 in. flat washer
- (1) 1 3/4 in. x 1/4 in.-28 thread bolt
- (1) Sleeve: Flat, 5/8 O.D. x 1/4 in. I.D.
- (1) Sleeve: Tapered, 5/8 O.D. x 1/4 in. I.D.
- (1) Aluminum Switch Arm
- (1) Switch Mounting Bracket
- (1) Ergonomic T-Handle
- (1) Rubber Grommet
- (1) "Push Off" Decal
Save Your Battery with a Turn of a Switch
JEGS Battery Disconnect Switches are designed to cut-off electrical power to help against electrical fires and offers theft protection when your vehicle is not in use. They are simple to install and give you the ability to cut power at a moment's notice. Disconnect Switches are mandated by the NHRA for Racing Vehicles equipt with alternators. Available in various combinations to fit your vehicle application.
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.