Most cars were built with rear brakes that do little more than hold the car steady, and they fade quickly once a big front kit starts doing more of the work. This Pro+ kit replaces them with 13 in. 2-piece rotors and 6-piston calipers, giving the rear axle the clamping force and heat capacity to stop repeatedly without fade.

Baer 4262290R Pro+ Rear Disc Brake Kit Features:

• Fits 1979-1992 Ford Mustang.
• Powder Coated Finish.
• Stainless Steel Pistons, Abutments and Noise Suppression Clips.
• Staggered Pistons to Minimize Uneven Pad Wear.
• Dual Seals, Dust/Weather and Pressure.
• 2-Piece Slot, Drilled, Zinc-Plate Rotor with Billet Aluminum Hat.
• 13 in. x 1.100 in. 2-Piece rotors with a slotted, drilled and zinc plated finish.
• Red caliper finish.
• 6P caliper, 6 pistons.
• Uses D0731 pads.
• Wheel bolt pattern 4x4.25.
• Stainless Braided Brake Hoses.
• Parking brake included.
• Fits 79-92 Mustang (Fox) with OE 8.8 in. c-clip rear end and 4 lug axles (Master cylinder upgrade is recommended, see Note below).
• For vehicles with OE Ford 8.8 inch C-clip Rear End (4 Lug).
• Requires a minimum 17 in. wheel diameter; verify wheel clearance with Baer template Q085H.
• Sold as a kit.