The JEGS 555-630129 front disc brake conversion kit replaces the factory drum brakes on 1970 Ford Mustang models with a manual transmission. It bolts onto the factory V8 drum brake spindles and pairs 11 in. standard vented rotors and four-piston calipers with an 8 in. power booster, OE-style master cylinder, and proportioning valve for a firm, balanced pedal.

JEGS 555-630129 Front Standard Disc Brake Conversion Kit Features:

• Fits 1970 Ford Mustang models with a manual transmission
• Bolt-on installation using the factory Mustang V8 drum brake spindles
• Converts the front hubs to a 5 x 4 1/2 in. wheel bolt pattern
• 11 in. diameter standard vented rotors measure 1.00 in. thick for consistent heat control
• Four-piston iron calipers with a zinc-plated finish resist corrosion
• Semi-metallic brake pads come pre-loaded in the calipers
• 8 in. power booster lowers pedal effort
• 1 in. bore dual reservoir cast iron master cylinder with a natural finish
• Disc/drum proportioning valve with built-in 10 lb residual valve balances front-to-rear bias

JEGS 555-630129 Front Standard Disc Brake Conversion Kit Includes:

• (1) Power brake booster
• (1) Master cylinder
• (1) Brake pedal for manual transmission models
• (1) Proportioning valve
• (2) Standard Vented Brake Rotors
• (2) Calipers with brake pads
• (2) Caliper mounting brackets
• (2) Rubber brake hoses
• (1) Set of wheel bearings, seals, and dust caps
• (1) Pair of disc brake dust shields
• (1) Mounting hardware kit

JEGS 555-630129 Front Standard Disc Brake Conversion Kit Notes:

• Works with V8 drum brake spindles only; does not fit 6-cylinder models
• Requires a minimum wheel size of 14 x 7 in.
• Front application only; rear brakes are not included
• Spindles are not included; the original drum brake spindles are reused