ATK Engines Remanufactured Crate Engine for Marine Applications with 2007-2011 Chevy 4.3L V6
059-DMX1







Chevrolet
Notes: Engine Break-In Procedure Use conventional or break-in oil (non-synthetic) for the first 600 miles of operation. Do not drive for long periods at any single speed, always vary your speed. Do not tow a trailer or put other heavy loads on the vehicle. Check the engine oil and coolant levels daily. At 600 Miles change the engine oil and filter using conventional (non-synthetic) oil. Check fuel and ignition settings; adjust valves (where applicable). After the first 5,000 of service synthetic engine oil may be used. Follow your vehicle owner’s manual for service intervals.
Specifications:
ATK builds remanufactured crate engines with a higher quality than new. Every engine is reverse engineered, allowing ATK to find and remove any factory original defect. This attention to detail and quality will save you time and money by keeping your boat out of the shop and on the water. Each engine is issued a certificate for testing that contains a serial number, compression, oil pressure, water temperature and testing time. Designed and built specifically for boating, ATK marine engines will provide long term durability along with maximum performance. Remanufactured crate engines are built to OE horsepower and torque specifications. ATK Remanufactured Crate Engines Warranty ATK Remanufactured Products Warranty and Break-In Procedures
Motor Vehicles
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
Tools:
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
Electrical Cords
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.