The high-performance version of FAST XR700, the XR3000 converts points-type distributors to electronic ignition. With 150% greater spark gap energy over stock points ignition, the XR3000 uses a high-output coil without ballast resistor and an optical trigger for precise ignition timing accuracy. Operating range up to 18 volts and 6,500 rpm's.
- LED status light for easy diagnostics
- 150% greater spark gap energy over stock points ignition
- Uses high-output coil without ballast resistor
- Optical trigger for precise ignition timing accuracy
- Fully sealed for protection from dirt, moisture, and vibration
- SMT (Surface Mount Technology) for reduced size and greater reliability
- Short circuit protection
- 50-State Legal (CARB E.O. #D-225-52)
- Operating Voltage: 6 to 18 volts, reverse polarity protected, negative ground
- Coil Current Limit: 4.5 amps internal short circuit protection (limit set at 7 amps)
- RPM Range: 6,500 RPM
- Primary Voltage Output: 400 volts (inductive discharge)
- Primary Energy Output: 90 millijoules with PS91 coil
- Peak Spark Gap Current: 100 milliamps with PS91 coil
- Spark Duration: 2800 microseconds at 2,000 RPM
- Dimensions: 5" L x 3" W x 1-1/2" H
- Weight: 1-1/2 pounds
Note: Not compatible with 6-volt electrical systems, as these may drop below 4 volts during cranking.
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.