Nu-Cast Engine Coatings are formulated to duplicate the original color of newly cast metals. It is specially formulated to withstand temperatures of 550° F and is extremely resistant to heat, gasoline, solvents, degreasers and moisture. Although it's tough chemical resistant qualities make it ideal for under the hood applications, it is also ideal for that custom look on all accessories. Nu-Cast, will keep that new look for detailing cast iron parts or the entire engine. Made for the antique restorer, show cars or the muscle car re-builder.
Application: Clean surface thoroughly, removing all grease, oil, loose paint and rust. Sand previously painted surfaces lightly being sure to feather all rough edges. Wipe part to be painted with a tack cloth being careful to remove all dust and paint particles. DO NOT PRIME. Apply NU-CAST directly to the surface to be painted. Apply a smooth even coat and lightly sand for a primer coat or spot prime. Hold can 12 to 16 inches away from the surface and spray in one direction using long even strokes. Repeat the process in the opposite direction. Wait 15 to 20 minutes before re-coating. If you touch up or re-coat surface after 2 hours, a light sanding will be required for best adhesion. Dries to the touch in 30 minutes, cured overnight. When using in temperatures below 70° F, dry time will be significantly increased. Parts to be sprayed should be at room temperature for best adhesion, appearance and durability.
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.